Datasheet

JN5169M0x All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2016. All rights reserved.
Product data sheet Rev. 3.0 — 19 September 2016 13 of 27
NXP Semiconductors
JN5169-001-M0x-2
ZigBee 3.0, ZigBee PRO and IEEE802.15.4 modules
[1] To reach the maximum TX power, 2.8 V is the minimum on V
DD
.
[2] Up to an extra 2.5 dB of attenuation is available if required.
13. Application information
13.1 Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, according to Part 15 of the FCC Rules, see Ref. 4
. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules, see Ref. 4
. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference
S
RX
receiver sensitivity nominal for 1 % PER, as per 802.15.4 - 100 - dBm
P
i(RX)(max)
maximum receiver input
power
1 % PER, measured as sensitivity - 5 - dBm

RSSI
RSSI variation 100 dBm to 25 dBm; available through
JN5169M0x Integrated Peripherals API
4- +4dB
Transmitter
M00
P
o
output power I
DD
= 27.2 mA
[1]
-10-dBm
I
DD
= 23.6 mA
[1]
-8.5-dBm
P
o(cr)
control range output
power
in 6 major steps and then 4 fine steps
[2]
- 42 - dB
M03
P
o
output power I
DD
= 27.2 mA
[1]
-10-dBm
I
DD
= 23.6 mA
[1]
-8.5-dBm
P
o(cr)
control range output
power
in 6 major steps and then 4 fine steps
[2]
- 42 - dB
M06
P
o
output power
[1]
-22-dBm
Table 11. Radio transceiver characteristics: +25 C
…continued
V
DD
= 2 V to 3.6 V; unless otherwise specified.
Symbol Parameter Conditions Min Typ Max Unit