Datasheet

PCB Information
MIMXRT1050 EVK Board Hardware User’s Guide, User's Guide, Rev. 1, 11/2017
NXP Semiconductors 15
2.17. User Interface LED Indicator
There are four LED status indicators located on the EVK Board. The functions of these LEDs include:
• Main Power Supply(D3)
Green: DC 5V main supply is normal.
Red: J2 input voltage is over 5.6V.
Off: the board is not powered.
• Reset RED LED(D15)
• OpenSDA LED(D16)
• USER LED(D18)
2.18. LCD Interface
The enhanced Liquid Crystal Display Interface (eLCDIF) is a general purpose display controller.
The eLCDIF block supports the following:
• Displays that support moving pictures and require the RGB interface mode (DOTCLK interface).
The eLCDIF provides fully programmable functionality to supported interfaces:
• Bus master interface to source frame buffer data for display refresh.
• 8/16/18/24/32 bit LCD data bus support available depending on I/O mux options.
• Programmable timing and parameters for DOTCLK LCD interfaces.
If developers want to use LCD, NXP provides an optional LCD module RK043FN02H-CT which has a
4.3 inches touch-screen and supports a resolution of up to 480*3(RGB)*272. This module contains two
FPC cables. The LCD interface can be connected to J8(A1-A40) and the CPT interface can be connected
to J8(B1-B6). LCD modules can be purchased from the NXP website.
3. PCB Information
The MIMXRT1050 EVK Board is made using standard 4-layer technology. The material used was FR-
4.The PCB stack-up information is shown in Table 7.