Datasheet

Quick Start Guide
8
SETTING UP THE SYSTEM
1
SD
Card
Insert the MicroSD card into socket J19
on the MEK CPU Board.
2
Connect USB
Debug Cable
Connect the micro-B end of a USB cable
into debug port, J18. Connect the other
end of the cable to a PC acting as a host
terminal.
Open the terminal window (i.e., Hyper
Terminal or Tera Term) and apply the
following configuration.
• Baud rate: 115200
• Data bits: 8
• Stop bit: 1
• Parity: None
• Flow control: None
3
Connect the Headphone
(Optional)
Connect the Headphone to the Audio
Jack J15 (close to USB type C Connector)
4
Connect Ethernet Cable
(Optional)
Connect an Ethernet cable to the
Ethernet Jack J14 (close to the Debug
port).
5
Connect USB type-C Cable
(Optional)
Connect the Type C Male connector of
the supplied USB Type-C male to Type- A
female cable to the Type-C connector J17
(Close to the SD slot).