Datasheet

Electrical Characteristics
i.MX 6Dual/6Quad Automotive and Infotainment Applications Processors, Rev. 6, 11/2018
NXP Semiconductors 85
1
ENET_COL has the same timing in 10-Mbit 7-wire interface mode.
4.12.5.1.4 MII Serial Management Channel Timing (ENET_MDIO and ENET_MDC)
The MDC frequency is designed to be equal to or less than 2.5 MHz to be compatible with the IEEE 802.3
MII specification. However the ENET can function correctly with a maximum MDC frequency of
15 MHz.
Figure 45 shows MII asynchronous input timings. Table 56 describes the timing parameters (M10–M15)
shown in the figure.
Figure 45. MII Serial Management Channel Timing Diagram
Table 55. MII Asynchronous Inputs Signal Timing
ID Characteristic Min Max Unit
M9
1
ENET_CRS to ENET_COL minimum pulse width 1.5 — ENET_TX_CLK period
Table 56. MII Serial Management Channel Timing
ID Characteristic Min Max Unit
M10 ENET_MDC falling edge to ENET_MDIO output invalid
(minimum propagation delay)
0— ns
M11 ENET_MDC falling edge to ENET_MDIO output valid
(maximum propagation delay)
—5 ns
M12 ENET_MDIO (input) to ENET_MDC rising edge setup 18 — ns
M13 ENET_MDIO (input) to ENET_MDC rising edge hold 0 — ns
M14 ENET_MDC pulse width high 40% 60% ENET_MDC period
M15 ENET_MDC pulse width low 40% 60% ENET_MDC period
ENET_MDC (output)
ENET_MDIO (output)
M14
M15
M10
M11
M12
M13
ENET_MDIO (input)