Datasheet

Revision History
i.MX 6Dual/6Quad Automotive and Infotainment Applications Processors, Rev. 6, 11/2018
NXP Semiconductors 169
Rev. 2 04/2013 Substantive changes throughout this document are as follows:
• Incorporated standardized signal names. This change is extensive throughout.
Added reference to EB792, i.MX Signal Name Mapping.
• Figures updated to align to standardized signal names.
• Aligned references to FCBGA to read FCPBGA throughout document.
• Updated references to eMMC standard to include 4.41.
• Table 2, “i.MX 6Dual/6Quad Modules List,” Changed reference to Global Power Controller to read
General Power Controller.
• Table 4, “Absolute Maximum Ratings,” Added VDD_ARM23_IN to Core supply voltages.
• Table 6 “Operating Ranges”: Run Mode - LDO Enabled, VDD_ARM_IN/VDD_ARM23_IN, 792 MHz,
input voltage minimum changed to 1.275V and VDD_ARM CAP minimum changed to 1.150V.
NVCC_NAND, changed to NVCC_NANDF.
• Table 6 “Operating Ranges”: Added reference for information on product lifetime: i.MX 6Dual/6Quad
Product Usage Lifetime Estimates Application Note, AN4724.
• Table 9. “Maximum Supply Currents”: Added current for i.MX6Dual
• Table 10 “Stop Mode Current and Power Consumption”: Added SNVS Only mode.
• Table 22 “GPIO I/O DC Parameters”: Removed parameters Iskod and Isspp.
• Table 48, “ECSPI Master Mode Timing Parameters,” Updated parameter CS6 ECSPIx_SSx Lag Time
(CS hold time) Min from Half SCLK period to Half SCLK period-2.
• Table 77 “SD/eMMC4.3 Interface Timing Specification,” eMMC parameter SD8 value Min updated from
5.6 ns to 1.5 ns.
• Table 89 RGMII Signal Switching Specifications RGMII parameter TskewR units corrected.
• Table 134 “21 x 21 mm Functional Contact Assignments,” Updated GPIO_1 Ball Name value to PU
(100K).
• Table 134 “21 x 21 mm Functional Contact Assignments,” Clarification of ENET_REF_CLK naming.
• Removed section, EIM Signal Cross Reference. Signal names are now aligned with reference manual.
• Section 1.2, “Features added bulleted item regarding the SOC-level memory system.
• Section 4.2.1, “Power-Up Sequence” updated wording.
• Section 4.3.2, “Regulators for Analog Modules”: Added NVCC_PLL_OUT to section heading.
• Section 4.6.1, “XTALI and RTC_XTALI (Clock Inputs) DC Parameters”: Added section.
• Section 4.10, “General-Purpose Media Interface (GPMI) Timing” figures replaced, tables revised.
Table 99. i.MX 6Dual/6Quad Data Sheet Document Revision History (continued)
Rev.
Number
Date Substantive Change(s)