Datasheet

NXP Semiconductors

FRDM33772BSPIEVB

Featuring the MC33772B battery cell controller IC

User guide Rev. 1.0 — 22 June 2018

15 / 20

Jumper Setting Description

JP32 2-3 RESET

Table 12. Jumper Setting to Work with Arduino R3

Arduino R3 has a single-line connector that connects to the outer row of the FRDM33772BSPIEVB

connectors.

Jumper Setting Description

J22 1-2 RESET

J26 open —

J27 1-2 CSB

J28 open —

J29 1-2 MOSI

J30 open —

J31 open —

J32 1-2 MISO

J33 open —

J34 open —

J36 open —

J37 1-2 SLCK

J38 open —

J41 open —

J42 open —

JP25 1-2 VDDIO

JP30 2-3 FAULT

JP31 1-2 3.3 V

JP32 2-3 RESET

5.2 Freedom board configuration

The layout of the connectors allow MCU development boards mentioned in Section 5.1

"Compatible NXP MCU development platforms" to be mounted directly to the

FRDM33772BSPIEVB. See Figure 6. When both boards are connected together, the

SPI connector is directly connected with the MCU SPI pins. The routing of SPI signals

through the Arduino connectors depends on the specific Freedom board being used. In

this configuration, power is supplied to the FRDM33772BSPIEVB through a USB cable

connected between the Freedom board and a PC. No external power supply is required.