Datasheet

Table 38. EMVSIM1 signal descriptions (continued)
Chip signal name Module signal
name
Description I/O
EMVSIM1_ PD EMVSIM_PD Card Presence Detect. Signal indicating presence or removal of
card
I
EMVSIM1_ RST EMVSIM_SRST Card Reset. Reset signal to Smart Card O
EMVSIM1_ VCCEN EMVSIM_VCC_EN Card Power Enable. This signal controls the power to Smart Card O
4.3.8 Human-machine interfaces (HMI)
Table 39. GPIO signal descriptions
Chip signal name Module signal
name
Description I/O
PTA[31:0]
1
PORTA31–PORTA0 General-purpose input/output I/O
PTB[31:0]
1
PORTB31–PORTB0 General-purpose input/output I/O
PTC[31:0]
1
PORTC31–PORTC0 General-purpose input/output I/O
PTD[31:0]
1
PORTD31–PORTD0 General-purpose input/output I/O
PTE[31:0]
1
PORTE31–PORTE0 General-purpose input/output I/O
1. The available GPIO pins depends on the specific package. See the signal multiplexing section for which exact GPIO
signals are available.
Table 40. TSI0 signal descriptions
Chip signal name Module signal
name
Description I/O
TSI0_CH[15:0] TSI[15:0] TSI capacitive pins. Switches driver that connects directly to the
electrode pins TSI[15:0] can operate as GPIO pins.
I/O
4.4 KL82 Pinouts
The below figures show the pinout diagrams for the devices supported by this
document. Many signals may be multiplexed onto a single pin. To determine what
signals can be used on which pin, see the previous section.
Pinouts
Kinetis KL82 Microcontroller, Rev. 3, 08/2016
51
NXP Semiconductors