Quick Start Guide FRDM-KE16Z FREEDOM DEVELOPMENT PLATFORM
Quick Start Guide GET TO KNOW THE FRDM-KE16Z Power/ OpenSDA Micro USB J2 I /O Header Accelerometer/ Magnetometer J3 I/O Header NC-2 VDD-4 RESET-6 P3V3-8 P5V_LDO_OUT-10 GND-12 GND-14 J1 I /O P5-9V_VIN-16 1-PTC4 3-PTB3 5-PTB5 7-PTB4 9-PTD1 11-PTD0 13-PTC1 15-PTC0 PTC3-2 PTC2-4 PTA7-6 PTA6-8 PTA1-10 PTA0-12 1-PTE8 3-PTE0 5-PTE1 7-PTE2 9-PTD7 11-PTE3 Header J4 I/O Header SWD Header SW2 SW3 Touch Electrode1 RGB LED MSCAN Header Figure 1: FRDM-KE16Z Callouts 2 GND-19 PTE10-17 PTE11-15 PTD5-13 PTD6-
www.nxp.com STEP-BY-STEP INSTRUCTIONS 1. Connect the FRDM-KE16Z board to a PC using the included micro-USB cable to the Power/OpenSDA Micro USB connector (J6) of the FRDM-KE16Z board. A power LED will illuminate. 2. The FRDM-KE16Z comes preprogrammed with a demo which leverages the onboard accelerometer. When the board is lying flat, the RGB LED is turned off. When the board is tilted, the red or blue LEDs will gradually illuminate based on the degree of tilt. 3.
SUPPORT Visit www.nxp.com/support for a list of phone numbers within your region. WARRANTY Visit www.nxp.com/warranty for complete warranty information. Get Started Download installation software and documentation under “Jump Start Your Design” at www.nxp.com/FRDM-KE16Z. www.nxp.com NXP, the NXP logo and Kinetis are trademarks of NXP B.V. All other product or service names are the property of their respective owners. © 2018 NXP B.V.