Datasheet

Analog Integrated Circuit Device Data

44 Freescale Semiconductor

07XSC200

5.4.4.10 Default Device Configuration

The default device configuration is explained by the following:

• HS output is commanded by the corresponding IN input or On bit through the SPI. The medium slew-rate is used,

• HS output is fully protected by the Xenon overcurrent profile by default, the severe short-circuit protection, the undervoltage

and the overtemperature protection. The auto-retry feature is enabled,

• OpenLoad in ON and OFF state and HS shorted to V

PWR

detections are available,

• No current recopy and no analog temperature feedback active,

• Overvoltage protection is enabled,

• SO reporting fault status must be ignored,

•V

failure detection is disabled.