Datasheet

Analog Integrated Circuit Device Data

4 Freescale Semiconductor

07XSC200

8, 33 VPWR Power Positive Power Supply

Pin 8 is a positive supply for quiet and accurate control. Pin 33 is a power supply

for the high current switch. These pins must be shorted at board level.

Connecting a heatsink to pin 33 guarantees optimal heat-evacuation

properties.

9 to 16 HS1 Output High Side Output

Protected 7.0 m high side power output pin to the load. Those pins must be

shorted at board level.

26 FSI Input Fail-safe Input

The value of the resistance connected between this pin and ground determines

the state of the outputs after a watchdog time-out occurs.

27 CSNS Output Output Current

Monitoring

This pin is used to output a current proportional to the designated HS0-1 output.

28 CLOCK Input Reference Clock

This pin is used to apply a reference clock used to control the outputs in PWM

mode through embedded PWM module.

29 IN0 Input Direct Input 0

This input pin is used to directly control the output HS0.

30 IN1 Input Direct Input 1

This input pin is used to directly control the output HS1.

31 FSB Output Fault Status (Active

Low)

This is an open drain configured output requiring an external pull-up resistor to

VDD for fault reporting.

32 WAKE Input Wake

This pin is used to input a Logic [1] signal so as to enable the watchdog timer

function.

Table 1. 07XSC200 Pin Definitions (continued)

Number

Pin Name

Function

Formal Name Definition