Datasheet

Analog Integrated Circuit Device Data

Freescale Semiconductor 49

10XSC425

6.4.4.9 Previous Address SOA4 : SOA0 = 10111 (diagr2)

The returned data is the product ID. Bits OD2:OD0 are set to 011 for Protected Dual 10 m and 25 m high side Switches.

Default Device configuration

The default device configuration is explained by the following:

• HS output is commanded by corresponding IN input or On bit through the SPI. The medium slew rate is used,

• HS output is fully protected by the Xenon overcurrent profile by default, the severe short-circuit protection, the undervoltage,

and the overtemperature protection. The auto-retry feature is enabled,

• OpenLoad in ON and OFF state and HS shorted to V

PWR

detections are available,

• No current recopy and no analog temperature feedback active,

• Overvoltage protection is enabled,

• SO reporting fault status from HS0,

•V

failure detection is disabled.