Datasheet

PCA9698 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2010. All rights reserved.
Product data sheet Rev. 3 — 3 August 2010 2 of 48
NXP Semiconductors
PCA9698
40-bit Fm+ I
2
C-bus advanced I/O port with RESET, OE and INT
 2.3 V to 5.5 V operation with 5.5 V tolerant I/Os
 40 configurable I/O pins that default to inputs at power-up
 Outputs:
 Programmable totem-pole (10 mA source, 25 mA sink) or open-drain (25 mA sink)
with controlled edge rate output structure. Default to totem-pole on power-up.
 Active LOW Output Enable (OE
) input pin 3-states all outputs. Polarity can be
programmed to active HIGH through the I
2
C-bus. Defaults to OE on power-up.
 Output state change programmable on the Acknowledge or the STOP Command to
update outputs byte-by-byte or all at the same time respectively. Defaults to
Acknowledge on power-up.
 Inputs:
 Open-drain active LOW Interrupt (INT
) output pin allows monitoring of logic level
change of pins programmed as inputs
 Programmable Interrupt Mask Control for input pins that do not require an interrupt
when their states change
 Polarity Inverter register allows inversion of the polarity of the I/O pins when read
 Active LOW SMBus Alert (SMBALERT
) output pin allows to initiate SMBus ‘Alert
Response Address’ sequence. Own slave address sent when sequence initiated.
 Active LOW Reset (RESET
) input pin resets device to power-up default state
 GPIO All Call address allows programming of more than one device at the same time
with the same parameters
 64 programmable slave addresses using 3 address pins
 Readable Device ID (manufacturer, device type and revision)
 Designed for live insertion in PICMG applications
 Minimize line disturbance (I
OFF
and power-up 3-state)
 Signal transient rejection (50 ns noise filter and robust I
2
C-bus state machine)
 Low standby current
 −40 °C to +85 °C operation
 ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per
JESD22-A115, and 1000 V CDM per JESD22-C101
 Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA
 Packages offered: TSSOP56, and HVQFN56
3. Applications
 Servers
 RAID systems
 Industrial control
 Medical equipment
 PLCs
 Cell phones
 Gaming machines
 Instrumentation and test measurement