Datasheet
PCA9539_PCA9539R All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 8 — 26 November 2014 21 of 38
NXP Semiconductors
PCA9539; PCA9539R
16-bit I
2
C-bus and SMBus low power I/O port with interrupt and reset
[1] V
DD
must be lowered to 0.2 V for at least 5 s in order to reset part.
[2] Each I/O must be externally limited to a maximum of 25 mA and each octal (IO0_0 to IO0_7 and IO1_0 to IO1_7) must be limited to a
maximum current of 100 mA for a device total of 200 mA.
[3] The total current sourced by all I/Os must be limited to 160 mA (80 mA for IO0_0 through IO0_7 and 80 mA for IO1_0 through IO1_7).
11. Dynamic characteristics
Select inputs A0, A1 and RESET
V
IL
LOW-level input voltage 0.5 - +0.3V
DD
V
V
IH
HIGH-level input voltage 0.7V
DD
-5.5V
I
LI
input leakage current 1- +1 A
Table 15. Static characteristics for PCA9539PW/Q900 …continued
V
DD
= 3.0 V to 5.5 V; V
SS
=0V; T
amb
=
40
C to +125
C; unless otherwise specified.
Symbol Parameter Conditions Min Typ Max Unit
Table 16. Dynamic characteristics
Symbol Parameter Conditions Standard-mode
I
2
C-bus
Fast-mode I
2
C-bus Unit
Min Max Min Max
f
SCL
SCL clock frequency 0 100 0 400 kHz
t
BUF
bus free time between a STOP and
START condition
4.7 - 1.3 - s
t
HD;STA
hold time (repeated) START condition 4.0 - 0.6 - s
t
SU;STA
set-up time for a repeated START
condition
4.7 - 0.6 - s
t
SU;STO
set-up time for STOP condition 4.0 - 0.6 - s
t
VD;ACK
data valid acknowledge time
[1]
0.3 3.45 0.1 0.9 s
t
HD;DAT
data hold time 0 - 0 - ns
t
VD;DAT
data valid time
[2]
300 - 50 - ns
t
SU;DAT
data set-up time 250 - 100 - ns
t
LOW
LOW period of the SCL clock 4.7 - 1.3 - s
t
HIGH
HIGH period of the SCL clock 4.0 - 0.6 - s
t
f
fall time of both SDA and SCL signals
[3]
-30020+0.1C
b
300 ns
t
r
rise time of both SDA and SCL signals
[3]
- 1000 20 + 0.1C
b
300 ns
t
SP
pulse width of spikes that must be
suppressed by the input filter
- 50 - 50 ns
Port timing
t
v(Q)
data output valid time
[4]
- 200 - 200 ns
t
su(D)
data input set-up time 150 - 150 - ns
t
h(D)
data input hold time 1 - 1 - s
Interrupt timing
t
v(INT_N)
valid time on pin INT -4 - 4s
t
rst(INT_N)
reset time on pin INT -4 - 4s