Datasheet

NX5DV715 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2011. All rights reserved.
Product data sheet Rev. 3 — 4 November 2011 7 of 20
NXP Semiconductors
NX5DV715
Dual supply 1-of-2 VGA switch
[1] All typical values are measured at V
CC(B)
=5V, V
CC(A)
= 3.3 V and T
amb
=25C unless otherwise specified.
[2] Measured at identical V
CC
, temperature and input voltage.
[3] Flatness is defined as the difference between the maximum and minimum value of ON resistance measured at identical V
CC
and
temperature.
[4] Guarantees the LOW level.
[5] Guarantees the HIGH level.
R
ON
ON resistance mismatch
between channels
V
I
= GND to 0.7 V; I
SW
= 10 mA
[2]
-0.5-
R
ON(flat)
ON resistance (flatness) V
I
= GND to 0.7 V; I
SW
= 10 mA
[3]
-0.5-
C
S(OFF)
OFF-state capacitance - 4.5 - pF
C
S(ON)
ON-state capacitance - 12 - pF
SDAn, SCLn
I
S(OFF)
OFF-state leakage
current
V
CC(B)
= 5.5 V; V
CC(A)
= 3.6 V; SCL0,
SDA0, SCL1, SCL2, SDA1, SDA2 =
V
CC(A)
or GND; V
O
= 0 V to V
CC(B)
;
EN = GND; See Figure 3
[5]
--1 A
R
ON
ON resistance V
CC(A)
=2 V; V
I
= 0.4 V; I
SW
= 2mA;
See Figure 5 and Figure 7
-9-
C
S(ON)
ON-state capacitance - 15 - pF
R
PU
pull-up resistance - 4.7 - k
Control Logic (SEL, EN)
V
IH
HIGH-level input voltage V
CC(A)
= 2.3 V to 2.7 V 1.7 - V
V
CC(A)
= 3.0 V to 3.6 V 2.0 - V
V
CC(A)
= 4.5 V to 5.5 V 0.7V
CC(A)
-V
V
IL
LOW-level input voltage V
CC(A)
= 2.3 V to 2.7 V - - 0.7 V
V
CC(A)
= 3.0 V to 3.6 V - - 0.8 V
V
CC(A)
= 4.5 V to 5.5 V - - 0.3V
CC(A)
V
V
H
hysteresis voltage - 50 - mV
I
I
input leakage current V
CC(A)
= 5.5 V; V
I
=GNDtoV
CC(A)
--1 A
Table 8. Static characteristics
…continued
V
CC(B)
= 4.5 V to 5.5 V; V
CC(A)
= 2 V to 5.5 V, unless otherwise specified; Voltages are referenced to GND (ground = 0 V)
Symbol Parameter Conditions T
amb
= 40 Cto+85C Unit
Min Typ
[1]
Max