Datasheet

Chip Configuration Module (CCM)
Freescale Semiconductor 27-7
5. Clock mode selections
6. Chip select configuration
These functions are described here.
27.6.1 Reset Configuration
During reset, the pins for the reset override functions are immediately configured to known states.
Table 27-7 shows the states of the external pins while in reset.
If the RCON pin is not asserted during reset, the chip configuration and the reset configuration pin
functions after reset are determined by the RCON register or fixed defaults, regardless of the states of the
external data pins. The internal configuration signals are driven to levels specified by the RCON register’s
reset state for default module configuration.
If the RCON pin is asserted during reset, then various chip functions, including the reset configuration pin
functions after reset, are configured according to the levels driven onto the external data pins. (See
Table 27-8) The internal configuration signals are driven to reflect the levels on the external configuration
pins to allow for module configuration.
NOTE
During reset, the CLKMOD pins always determine the clock mode,
regardless of the RCON
pin state.
Table 27-7. Reset Configuration Pin States During Reset
Pin
Pin
Function
1
1
If the external RCON pin is not asserted during reset, pin functions are determined by the
default operation mode defined in the RCON register. If the external RCON
pin is asserted, pin
functions are determined by the override values driven on the external data bus pins.
I/O
Output
State
Input
State
D[26:24, 21, 19:16],
PA[2:0], PB[5, 3:0]
Digital I/O or primary
function
Input — Must be driven
by external logic
RCON RCON
function for all
modes
2
2
During reset, the external RCON pin assumes its RCON pin function, but this pin changes to
the function defined by the chip operation mode immediately after reset. See Table 27-8.
Input — Internal weak
pull-up device
CLKMOD1, CLKMOD0 Not affected Input — Must be driven by
external logic
Table 27-8. Configuration During Reset
1
Pin(s) Affected
Default
Configuration
Override Pins
in Reset
2,34
Function
D[31:0], R/W
, TA, TEA,
TSIZ[1:0], TS
, TIP, OE,
A[23:0], BS[3:0]
, CS[3:0]
RCON0 = 0
D[26,17:16] Chip Mode Selected
111 Master mode
110 Single-chip mode
5
100 or 0xx Reserved
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3