Datasheet

Synchronous DRAM Controller Module
Freescale Semiconductor 15-23
15.3.5 Mode Register Initialization
When DACR[IMRS] is set, a bus cycle initializes the mode register. If the mode register setting is read on
A[10:0] of the SDRAM on the first bus cycle, the bit settings on the corresponding processor address pins
must be determined while being aware of masking requirements.
Table 15-30 lists the desired initialization setting:
Next, this information is mapped to an address to determine the hexadecimal value.
Although A[31:20] corresponds to the address programmed in DACR0, according to how DACR0 and
DMR0 are initialized, bit 19 must be set to hit in the SDRAM. Thus, before the mode register bit is set,
DMR0[19] must be set to enable masking.
15.3.6 Initialization Code
The following assembly code initializes the SDRAM example.
Table 15-30. Mode Register Initialization
Processor Pins SDRAM Pins Mode Register Initialization
A20 A10 Reserved X
A19 A9 WB 0
A18 A8 Opmode 0
A17 A7 Opmode 0
A9 A6 CASL 0
A10 A5 CASL 0
A11 A4 CASL 1
A12 A3 BT 0
A13 A2 BL 0
A14 A1 BL 0
A15 A0 BL 0
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Field
Setting xxxx_xxxx_xxxx_000x
(hex) 0000
1514131211109876543210
Field V
Setting 0000_100x_xxxx_xxxx
(hex) 0800
Table 15-31. Mode Register Mapping to A[31:0]
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3