Datasheet

Signal Descriptions
Freescale Semiconductor 14-11
TEST Reserved, should be connected to VSS. I
TCK JTAG test logic clock. I
TIP
Asserted to indicate that a bus transfer is in progress. Negated
during idle bus cycles.
O
TS Asserted during the first CLKOUT cycle of a transfer when
address and attributes are valid.
O
UCTS[1:0] Signals UART that it can begin data transmission. I
URTS[1:0] Automatic UART request to send outputs. O
URXD[2:0] Receiver serial data inputs. I
UTXD[2:0] Transmitter serial data outputs. O
XTAL Internal oscillator connection to the external crystal. O
Table 14-3. MCF5282 Signals and Pin Numbers Sorted by Function
MAPBGA Pin
Pin Functions
Description
Primary
I/O
Internal
Pull-up
1
Primary
2
Secondary Tertiary
Reset
R11 RSTI — — Reset in IYes
P11 RSTO — — Reset out O —
Clock
T8 EXTAL — — External clock/crystal in I —
R8 XTAL — — Crystal drive O —
N7 CLKOUT — — Clock out O —
Chip Configuration/Mode Selection
R14 CLKMOD0 — — Clock mode select IYes
T14 CLKMOD1 — — Clock mode select IYes
T11 RCON — — Reset configuration enable IYes
H1 D26 PA2 — Chip mode I/O —
K2 D17 PB1 — Chip mode I/O —
K3 D16 PB0 — Chip mode I/O —
J4 D19 PB3 — Boot device/data port size I/O —
K1 D18 PB2 — Boot device/data port size I/O —
J2 D21 PB5 — Output pad drive strength I/O —
Table 14-2. MCF5282 Alphabetical Signal Index (continued)
Abbreviation Function I/O
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3