Datasheet

Power Management
7-4 Freescale Semiconductor
7.2.3.2 Low-Power Control Register (LPCR)
The LPCR controls chip operation and module operation during low-power modes.
7 6543210
Field LPMD — STPMD — LVDSE —
Reset 0000_0010
R/W R/W
Address IPSBAR + 0x0011_0007
Figure 7-2. Low-Power Control Register (LPCR)
Table 7-4. LPCR Field Descriptions
Bits Name Description
7–6 LPMD Low-power mode select. Used to select the low-power mode the chip
enters once the ColdFire CPU executes the STOP instruction. These bits
must be written prior to instruction execution for them to take effect. The
LPMD[1:0] bits are readable and writable in all modes. Ta bl e 7 -5 illustrates
the four different power modes that can be configured with the LPMD bit
field.
5 — Reserved, should be cleared.
4–3 STPMD PLL/CLKOUT stop mode. Controls PLL and CLKOUT operation in stop
mode as shown in Table 7-6
2 — Reserved, should be cleared.
1 LVDSE LDV standby enable. Controls whether the PMM enters VREG Standby
Mode (LVD disabled) or VREG Pseudo-Standby (LVD enabled) mode when
the PMM receives a power down request. This bit has no effect if the
RCR[LVDE] bit is a logic 0.
1 VREG Pseudo-Standby mode (LVD enabled on power down request).
0 VREG Standby mode (LVD disabled on power down request).
0 — Reserved, should be cleared.
Table 7-5. Low-Power Modes
LPMD[1:0] Mode
11 STOP
10 WAIT
01 DOZE
00 RUN
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3