Datasheet

Resets and Interrupts
MC9S12DP256 — Revision 1.1
Resets and Interrupts
Latching of Interrupts
XIRQ is always level triggered and IRQ can be selected as a level
triggered interrupt. These level triggered interrupt pins should only be
released during the appropriate interrupt service routine. Generally the
interrupt service routine will handshake with the interrupting logic to
release the pin. In this way, the MCU will never start the interrupt service
sequence only to determine that there is no longer an interrupt source.
In event that this does occur the trap vector will be taken.
If IRQ
is selected as an edge triggered interrupt, the hold time of the level
after the active edge is independent of when the interrupt is serviced. As
long as the minimum hold time is met, the interrupt will be latched inside
the MCU. In this case the IRQ edge interrupt latch is cleared
automatically when the interrupt is serviced.
All of the remaining interrupts are latched by the MCU with a flag bit.
These interrupt flags should be cleared during an interrupt service
routine or when interrupts are masked by the I bit. By doing this, the
MCU will never get an unknown interrupt source and take the trap
vector.
Table 24 Interrupt Vector Table
Vector Address Interrupt Source
CCR
Mask
Local Enable
HPRIO Value
to Elevate
$FFFE, $FFFF Reset None None –
$FFFC, $FFFD Clock Monitor fail reset None COPCTL (CME, FCME) –
$FFFA, $FFFB COP failure reset None COP rate select –
$FFF8, $FFF9 Unimplemented instruction trap None None –
$FFF6, $FFF7 SWI None None –
$FFF4, $FFF5 XIRQ X-Bit None –
$FFF2, $FFF3 IRQ I-Bit INTCR (IRQEN) $F2
$FFF0, $FFF1 Real Time Interrupt I-Bit CRGINT (RTIE) $F0
$FFEE, $FFEF Timer channel 0 I-Bit TMSK1 (C0I) $EE
$FFEC, $FFED Timer channel 1 I-Bit TMSK1 (C1I) $EC
$FFEA, $FFEB Timer channel 2 I-Bit TMSK1 (C2I) $EA
$FFE8, $FFE9 Timer channel 3 I-Bit TMSK1 (C3I) $E8
$FFE6, $FFE7 Timer channel 4 I-Bit TMSK1 (C4I) $E6
Freescale Semiconductor, I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...