Datasheet

Appendix A Electrical Characteristics
MC9S08SH32 Series Data Sheet, Rev. 2
Freescale Semiconductor 297
Stop2 mode supply current
C –40°C (C and M suffix) 0.94 –
P25°C (All parts) 1.25 –
P
5
85°C (C suffix only) 5 13.4 30 μA
5
P
5
125°C (M suffix only) S2I
DD
65 120
C –40°C (C and Msuffix) 0.83 –
P25°C (All parts) 1.1 –
P
5
85°C (C suffix only) 3 11.5 25 μA
P
5
125°C (M suffix only) 57 100
6 C RTC adder to stop2 or stop3
6
S23I
DDRTI
5 300 500 nA
3 300 500 nA
7 C LVD adder to stop3 (LVDE = LVDSE = 1) S3I
DDLVD
5 110 180 μA
3 90 160 μA
8 C Adder to stop3 for oscillator enabled
7
(EREFSTEN =1)
S3I
DDOSC
5,3 5 8 μA
1
Typical values are based on characterization data at 25°C. See Figure A-5 through Figure A-7 for typical
curves across temperature and voltage.
2
Max values in this column apply for the full operating temperature range of the device unless otherwise
noted.
3
All modules except ADC active, ICS configured for FBELP, and does not include any dc loads on port pins
4
All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins
5
Stop Currents are tested in production for 25 Con all parts. Tests at other temperatures depend upon the
part number suffix and maturity of the product. Freescale may eliminate a test insertion at a particular
temperature from the production test flow once sufficient data has been collectd and is approved.
6
Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the
higher current wait mode.
7
Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal
and low power mode (HGO = 0).
Table A-7. Supply Current Characteristics (continued)
Num C Parameter Symbol
V
DD
(V)
Typ
1
Max
2
Unit
PRELIMINARY