Datasheet

MC9S08MP16 Series Data Sheet, Rev. 2
Electrical Characteristics
Freescale Semiconductor8
2 Electrical Characteristics
2.1 Introduction
This section contains electrical and timing specifications for the MC9S08MP16 Series of microcontrollers available at the time
of publication.
35
——
PTE4 ADP12
6
C1IN4
6
36 23 25 PTB4 KBI1P4 ADP4
6
C2IN3
6
37 24 26 PTB5 KBI1P5 CMP2OUT
2
ADP5
6
C2IN4
6
38 25 27 PTB6 KBI1P6 CMP3OUT
3
ADP6
6
C3IN3
6
39 26
—
PTB7 KBI1P7 ADP7
6
C3IN4
6
40 27
—
PTE5 XTAL
41 28
—
PTE6 EXTAL
42 29
—
V
SS2
43
——
V
DD2
44 30 28 PTF0 BKGD MS
45 31 1 PTC0 KBI2P0 FTM2CH0
46 32 2 PTC1 KBI2P1 FTM2CH1
47 1 3 PTC2 KBI2P2 FTM2CH2
48 2 4 PTC3 KBI2P3 FTM2CH3
1
TCLK pin can be repositioned using TCLKPS in SOPT2. Default reset location is PTC7.
2
HSCMP2 output CMP2OUT can be repositioned using the CMP2OPS in the SOPT2 register.
Default reset location is PTD6.
3
HSCMP3 output CMP3OUT can be repositioned using the CMP3OPS in the SOPT2 register.
Default reset location is PTD7.
4
Pin is open drain with an internal pullup that is always enabled. Pin does not contain a clamp
diode to V
DD
and should not be driven above V
DD
. The voltage measured on the internally
pulled up RESET
will not be pulled to V
DD
. The internal gates connected to this pin are pulled
to V
DD
.
5
IIC pins SDA and SCL can be repositioned using IICPS in SOPT2. Default reset locations are
PTD0 and PTD1.
6
If ADC, HSCMP, or PGA is enabling a shared analog input pin, each has access to the pin.
Table 1. Pin Availability by Package Pin-Count (continued)
Pin Number <-- Lowest Priority --> Highest
48
32
LQFP
28 Port Pin Alt 1 Alt 2 Alt3 Alt4