Datasheet
Electrical Characteristics
MC9S08MP16 Series Data Sheet, Rev. 2
Freescale Semiconductor 17
Figure 9. Typical Run I
DD
vs. Bus Frequency (V
DD
= 5V)
10
C LVD adder to stop3 (LVDE = LVDSE = 1) S3I
DDLVD
5 110 180 A
3 90 160 A
11
C Adder to stop3 for oscillator enabled
8
(EREFSTEN =1)
S3I
DDOSC
5,3 5 8 A
1
Typical values are based on characterization data at 25C. See Figure 9 through Figure 14 for typical curves across
temperature and voltage.
2
Max values in this column apply for the full operating temperature range of the device unless otherwise noted.
3
All modules except ADC active, ICS configured for FBELP, and does not include any dc loads on port pins
4
All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins
5
All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins
6
Stop currents are tested in production for 25C on all parts. Tests at other temperatures depend upon the part
number suffix and maturity of the product. Freescale may eliminate a test insertion at a particular temperature from
the production test flow once sufficient data has been collected and is approved.
7
Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher
current wait mode.
8
Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal and low
power mode (HGO = 0).
Table 8. Supply Current Characteristics (continued)
Num C Parameter Symbol
V
DD
(V)
Typ
1
Max
2
Unit
0
2
4
6
8
10
12
14
16
2 8 16 20 25
fbus (MHz)
Run Idd (mA)
FBE FEI