Datasheet

MC9S08LL16 Series MCU Data Sheet, Rev. 7
Electrical Characteristics
Freescale Semiconductor10
NOTE
The classification is shown in the column labeled “C” in the parameter
tables where appropriate.
3.3 Absolute Maximum Ratings
Absolute maximum ratings are stress ratings only, and functional operation at the maxima is not
guaranteed. Stress beyond the limits specified in Table 4 may affect device reliability or cause permanent
damage to the device. For functional operating conditions, refer to the remaining tables in this section.
This device contains circuitry protecting against damage due to high static voltage or electrical fields;
however, it is advised that normal precautions be taken to avoid application of any voltages higher than
maximum-rated voltages to this high-impedance circuit. Reliability of operation is enhanced if unused
inputs are tied to an appropriate logic voltage level (for instance, either V
SS
or V
DD
) or the programmable
pull-up resistor associated with the pin is enabled.
Table 3. Parameter Classifications
P
Those parameters are guaranteed during production testing on each individual device.
C
Those parameters are achieved by the design characterization by measuring a statistically relevant
sample size across process variations.
T
Those parameters are achieved by design characterization on a small sample size from typical devices
under typical conditions unless otherwise noted. All values shown in the typical column are within this
category.
D
Those parameters are derived mainly from simulations.
Table 4. Absolute Maximum Ratings
Rating Symbol Value Unit
Supply voltage V
DD
–0.3 to 3.8 V
Maximum current into V
DD
I
DD
120 mA
Digital input voltage V
In
–0.3 to V
DD
+0.3 V
Instantaneous maximum current
Single pin limit (applies to all port pins)
1, 2, 3
1
Input must be current limited to the value specified. To determine the value of the required
current-limiting resistor, calculate resistance values for positive (V
DD
) and negative (V
SS
) clamp
voltages, then use the larger of the two resistance values.
2
All functional non-supply pins, except for PTB2 are internally clamped to V
SS
and V
DD
.
3
Power supply must maintain regulation within operating V
DD
range during instantaneous and
operating maximum current conditions. If positive injection current (V
In
> V
DD
) is greater than
I
DD
, the injection current may flow out of V
DD
and could result in external power supply going
out of regulation. Ensure external V
DD
load will shunt current greater than maximum injection
current. This will be the greatest risk when the MCU is not consuming power. Examples are: if
no system clock is present, or if the clock rate is very low (which would reduce overall power
consumption).
I
D
± 25 mA
Storage temperature range T
stg
–55 to 150 °C