Datasheet

Chapter 6 Parallel Input/Output
MC9S08JM60 Series Data Sheet, Rev. 3
Freescale Semiconductor 97
76543210
R
PTGPE5 PTGPE4 PTGPE3 PTGPE2 PTGPE1 PTGPE0
W
Reset00000000
Figure 6-34. Internal Pullup Enable for Port G Bits (PTGPE)
Table 6-33. PTGPE Register Field Descriptions
Field Description
5:0
PTGPEn
Internal Pullup Enable for Port G Bits — Each of these control bits determines if the internal pullup device is
enabled for the associated PTG pin. For port G pins that are configured as outputs, these bits have no effect and
the internal pullup devices are disabled.
0 Internal pullup device disabled for port G bit n.
1 Internal pullup device enabled for port G bit n.
76543210
R
PTGSE5 PTGSE4 PTGSE3 PTGSE2 PTGSE1 PTGSE0
W
Reset01111111
Figure 6-35. Output Slew Rate Control Enable for Port G Bits (PTGSE)
Table 6-34. PTGSE Register Field Descriptions
Field Description
5:0
PTGSEn
Output Slew Rate Control Enable for Port G Bits— Each of these control bits determine whether output slew
rate control is enabled for the associated PTG pin. For port G pins that are configured as inputs, these bits have
no effect.
0 Output slew rate control disabled for port G bit n.
1 Output slew rate control enabled for port G bit n.
76543210
R
PTGDS5 PTGDS4 PTGDS3 PTGDS2 PTGDS1 PTGDS0
W
Reset00000000
Figure 6-36. Output Drive Strength Selection for Port G (PTGDS)
Table 6-35. PTGDS Register Field Descriptions
Field Description
5:0
PTGDSn
Output Drive Strength Selection for Port G Bits — Each of these control bits selects between low and high
output drive for the associated PTG pin.
0 Low output drive enabled for port G bit n.
1 High output drive enabled for port G bit n.