Datasheet

Universal Serial Bus Device Controller (S08USBV1)
MC9S08JM60 Series Data Sheet, Rev. 3
Freescale Semiconductor 311
17.4 Functional Description
This section describes the functional behavior of the USB module. It documents data packet processing
for endpoint 0 and data endpoints, USB suspend and resume states, SOF token processing, reset conditions
and interrupts.
17.4.1 Block Descriptions
Figure 17-2 is the block diagram. The module’s sub-blocks and external signals are described in the
following sections. The module involves several major blocks — USB transceiver (XCVR), USB serial
interface engine (SIE), a 3.3 V regulator (VREG), endpoint buffer manager, shared RAM arbitration, USB
RAM and the SkyBlue gasket.
17.4.1.1 USB Serial Interface Engine (SIE)
The SIE is composed of two major functions: TX Logic and RX Logic. These major functions are
described below in more detail. The TX and RX logic are connected by a USB protocol engine which
manages packet flow to and from the USB module. The SIE is connected to the rest of the system via
1
EPSTALL
Endpoint Stall — When set, this bit indicates that the endpoint is stalled. This bit has priority over all other
control bits in the endpoint control register, but is only valid if EPTXEN=1 or EPRXEN=1. Any access to this
endpoint will cause the USB module to return a STALL handshake. Once an endpoint is stalled it requires
intervention from the host controller.
0 Endpoint n is not stalled
1 Endpoint n is stalled
0
EPHSHK
Endpoint Handshake — This bit determines if the endpoint will perform handshaking during a transaction
to the endpoint. This bit will generally be set unless the endpoint is isochronous.
0 No handshaking performed during a transaction to this endpoint (usually for isochronous endpoints)
1 Handshaking performed during a transaction to this endpoint
Table 17-19. Endpoint Enable/Direction Control
Bit Name
Endpoint Enable/Direction Control
4
EPCTLDIS
3
EPRXEN
2
EPTXEN
X00
Disable endpoint
X01Enable endpoint for IN(TX) transfers only
X10Enable endpoint for OUT(RX) transfers only
0 1 1 Enable endpoint for IN, OUT and SETUP transfers.
1 1 1 RESERVED
Table 17-18. EPCTLn Field Descriptions (continued)
Field Description