Datasheet

Break Module (BRK)
MC68HC908QB8 Data Sheet, Rev. 3
Freescale Semiconductor 195
17.2.2.3 Break Auxiliary Register
The break auxiliary register (BRKAR) contains a bit that enables software to disable the COP while the
MCU is in a state of break interrupt with monitor mode.
BDCOP — Break Disable COP Bit
This read/write bit disables the COP during a break interrupt. Reset clears the BDCOP bit.
1 = COP disabled during break interrupt
0 = COP enabled during break interrupt
17.2.2.4 Break Status Register
The break status register (BSR) contains a flag to indicate that a break caused an exit from wait mode.
This register is only used in emulation mode.
SBSW — SIM Break Stop/Wait
SBSW can be read within the break state SWI routine. The user can modify the return address on the
stack by subtracting one from it.
1 = Wait mode was exited by break interrupt
0 = Wait mode was not exited by break interrupt
17.2.2.5 Break Flag Control Register
The break control register (BFCR) contains a bit that enables software to clear status bits while the MCU
is in a break state.
Bit 7654321Bit 0
Read:0000000
BDCOP
Write:
Reset:00000000
= Unimplemented
Figure 17-6. Break Auxiliary Register (BRKAR)
Bit 7654321Bit 0
Read:
RRRRRR
SBSW
R
Write: Note
(1)
Reset: 0
R = Reserved 1. Writing a 0 clears SBSW.
Figure 17-7. Break Status Register (BSR)
Bit 7654321Bit 0
Read:
BCFERRRRRRR
Write:
Reset: 0
R
= Reserved
Figure 17-8. Break Flag Control Register (BFCR)