Datasheet

Registers
MC68HC908QB8 Data Sheet, Rev. 3
Freescale Semiconductor 187
Writing a 1 to CHxF has no effect.
1 = Input capture or output compare on channel x
0 = No input capture or output compare on channel x
CHxIE — Channel x Interrupt Enable Bit
This read/write bit enables TIM interrupt service requests on channel x.
1 = Channel x interrupt requests enabled
0 = Channel x interrupt requests disabled
MSxB — Mode Select Bit B
This read/write bit selects buffered output compare/PWM operation. MSxB exists only in the TSC0 and
TSC2 registers.
Setting MS0B causes the contents of TSC1 to be ignored by the TIM and reverts TCH1 to
general-purpose I/O.
Setting MS2B causes the contents of TSC3 to be ignored by the TIM and reverts TCH3 to
general-purpose I/O.
1 = Buffered output compare/PWM operation enabled
0 = Buffered output compare/PWM operation disabled
MSxA — Mode Select Bit A
When ELSxB:A ≠ 00, this read/write bit selects either input capture operation or unbuffered output
compare/PWM operation. See Table 16-2.
1 = Unbuffered output compare/PWM operation
0 = Input capture operation
When ELSxB:A = 00, this read/write bit selects the initial output level of the TCHx pin (see Table 16-2).
1 = Initial output level low
0 = Initial output level high
NOTE
Before changing a channel function by writing to the MSxB or MSxA bit, set
the TSTOP and TRST bits in the TIM status and control register (TSC).
Table 16-2. Mode, Edge, and Level Selection
MSxB MSxA ELSxB ELSxA Mode Configuration
X0 0 0
Output preset
Pin under port control; initial
output level high
X1 0 0
Pin under port control; initial
output level low
00 0 1
Input capture
Capture on rising edge only
0 0 1 0 Capture on falling edge only
0 0 1 1 Capture on rising or falling edge
01 0 0
Output compare
or PWM
Software compare only
0 1 0 1 Toggle output on compare
0 1 1 0 Clear output on compare
0 1 1 1 Set output on compare
1X 0 1
Buffered output
compare or
buffered PWM
Toggle output on compare
1 X 1 0 Clear output on compare
1 X 1 1 Set output on compare