Datasheet

Serial Communications Interface Module (SCI)
MC68HC908GP32 Data Sheet, Rev. 10
142 Freescale Semiconductor
Fast Data Tolerance
Figure 13-8 shows how much a fast received character can be misaligned without causing a noise error
or a framing error. The fast stop bit ends at RT10 instead of RT16 but is still there for the stop bit data
samples at RT8, RT9, and RT10.
Figure 13-8. Fast Data
For an 8-bit character, data sampling of the stop bit takes the receiver
9 bit times × 16 RT cycles + 10 RT cycles = 154 RT cycles.
With the misaligned character shown in Figure 13-8, the receiver counts 154 RT cycles at the point when
the count of the transmitting device is
10 bit times × 16 RT cycles = 160 RT cycles.
The maximum percent difference between the receiver count and the transmitter count of a fast 8-bit
character with no errors is
For a 9-bit character, data sampling of the stop bit takes the receiver
10 bit times × 16 RT cycles + 10 RT cycles = 170 RT cycles.
With the misaligned character shown in Figure 13-8, the receiver counts 170 RT cycles at the point when
the count of the transmitting device is
11 bit times × 16 RT cycles = 176 RT cycles.
The maximum percent difference between the receiver count and the transmitter count of a fast 9-bit
character with no errors is
13.4.3.6 Receiver Wakeup
So that the MCU can ignore transmissions intended only for other receivers in multiple-receiver systems,
the receiver can be put into a standby state. Setting the receiver wakeup bit, RWU, in SCC2 puts the
receiver into a standby state during which receiver interrupts are disabled.
IDLE OR NEXT CHARACTERSTOP
RT1 RT2 RT3 RT4 RT5 RT6 RT7 RT8 RT9
RT10 RT11 RT12 RT13 RT14 RT15 RT16
DATA
SAMPLES
RECEIVER
RT CLOCK
154 160–
154
--------------------------
100× 3.90%
˙
=
170 176–
170
--------------------------
100× 3.53%=