Datasheet

MC68HC908AP Family Data Sheet, Rev. 4
Freescale Semiconductor 209
Chapter 13
Serial Peripheral Interface Module (SPI)
13.1 Introduction
This section describes the serial peripheral interface (SPI) module, which allows full-duplex,
synchronous, serial communications with peripheral devices.
13.2 Features
Features of the SPI module include the following:
• Full-duplex operation
• Master and slave modes
• Double-buffered operation with separate transmit and receive registers
• Four master mode frequencies (maximum = bus frequency ÷ 2)
• Maximum slave mode frequency = bus frequency
• Serial clock with programmable polarity and phase
• Two separately enabled interrupts:
– SPRF (SPI receiver full)
– SPTE (SPI transmitter empty)
• Mode fault error flag with CPU interrupt capability
• Overflow error flag with CPU interrupt capability
• Programmable wired-OR mode
13.3 Pin Name Conventions and I/O Register Addresses
The text that follows describes the SPI. The SPI I/O pin names are SS (slave select), SPSCK (SPI serial
clock), CGND (clock ground), MOSI (master out slave in), and MISO (master in/slave out). The SPI
shares four I/O pins with four parallel I/O ports.
The full names of the SPI I/O pins are shown in Table 13-1. The generic pin names appear in the text that
follows.
Figure 13-1 summarizes the SPI I/O registers.
Table 13-1. Pin Name Conventions
SPI Generic
Pin Names:
MISO MOSI
SS SPSCK CGND
Full SPI
Pin Names:
SPI PTC2/MISO PTC3/MOSI PTC4/
SS PTC5/SPSCK
V
SS