Datasheet

ManualsBrandsNXP SEMICONDUCTORS ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller QFP 64 (14x14) 8-Bit 8 MHz I/O number 51

311

312

313

314

315

316

317

318

319

320

Table Of Contents

List of Sections
Table of Contents
List of Figures
List of Tables
Section 1. General Description
- 1.1 Contents
- 1.2 Introduction
- 1.3 Features
- 1.4 MCU Block Diagram
- 1.5 Pin Assignments
- 1.6 Pin Functions
- 1.7 I/O Pin Summary
- 1.8 Signal Name Conventions
- 1.9 Clock Source Summary
Section 2. Memory Map
- 2.1 Contents
- 2.2 Introduction
- 2.3 Unimplemented Memory Locations
- 2.4 Reserved Memory Locations
- 2.5 Input/Output (I/O) Section
Section 3. Random-Access Memory (RAM)
- 3.1 Contents
- 3.2 Introduction
- 3.3 Functional Description
Section 4. FLASH Memory
- 4.1 Contents
- 4.2 Introduction
- 4.3 Functional Description
- 4.4 FLASH Control Register
- 4.5 FLASH Page Erase Operation
- 4.6 FLASH Mass Erase Operation
- 4.7 FLASH Program/Read Operation
- 4.8 FLASH Block Protection
  - 4.8.1 FLASH Block Protect Register
- 4.9 Wait Mode
- 4.10 Stop Mode
Section 5. EEPROM
- 5.1 Contents
- 5.2 Introduction
- 5.3 Features
- 5.4 Functional Description
- 5.5 EEPROM Configuration
- 5.6 EEPROM Timebase Requirements
- 5.7 EEPROM Security Options
- 5.8 EEPROM Block Protection
- 5.9 EEPROM Programming and Erasing
  - 5.9.1 EEPROM Programming
  - 5.9.2 EEPROM Erasing
- 5.10 Low Power Modes
  - 5.10.1 Wait Mode
  - 5.10.2 Stop Mode
- 5.11 EEPROM Registers
Section 6. Configuration Register (CONFIG)
- 6.1 Contents
- 6.2 Introduction
- 6.3 Functional description
- 6.4 Configuration Register 1
- 6.5 Configuration Register 2
Section 7. Central Processor Unit (CPU)
- 7.1 Contents
- 7.2 Introduction
- 7.3 Features
- 7.4 CPU Registers
- 7.5 Arithmetic/Logic Unit (ALU)
- 7.6 Low-Power Modes
  - 7.6.1 Wait Mode
  - 7.6.2 Stop Mode
- 7.7 CPU During Break Interrupts
- 7.8 Instruction Set Summary
- 7.9 Opcode Map
Section 8. System Integration Module (SIM)
- 8.1 Contents
- 8.2 Introduction
- 8.3 SIM Bus Clock Control and Generation
- 8.4 Reset and System Initialization
  - 8.4.1 External Pin Reset
  - 8.4.2 Active Resets from Internal Sources
- 8.5 SIM Counter
- 8.6 Exception Control
- 8.7 Low-Power Modes
  - 8.7.1 Wait Mode
  - 8.7.2 Stop Mode
- 8.8 SIM Registers
Section 9. Clock Generator Module (CGM)
- 9.1 Contents
- 9.2 Introduction
- 9.3 Features
- 9.4 Functional Description
- 9.5 I/O Signals
- 9.6 CGM Registers
- 9.7 Interrupts
- 9.8 Low-Power Modes
  - 9.8.1 Wait Mode
  - 9.8.2 Stop Mode
- 9.9 CGM During Break Interrupts
- 9.10 Acquisition/Lock Time Specifications
Section 10. Monitor ROM (MON)
- 10.1 Contents
- 10.2 Introduction
- 10.3 Features
- 10.4 Functional Description
- 10.5 Security
- 10.6 Extended Security
Section 11. Timer Interface Module A (TIMA)
- 11.1 Contents
- 11.2 Introduction
- 11.3 Features
- 11.4 Pin Name Conventions
- 11.5 Functional Description
- 11.6 Interrupts
- 11.7 Low-Power Modes
  - 11.7.1 Wait Mode
  - 11.7.2 Stop Mode
- 11.8 TIMA During Break Interrupts
- 11.9 I/O Signals
  - 11.9.1 TIMA Clock Pin
  - 11.9.2 TIMA Channel I/O Pins
- 11.10 I/O Registers
Section 12. Timer Interface Module B (TIMB)
- 12.1 Contents
- 12.2 Introduction
- 12.3 Features
- 12.4 Pin Name Conventions
- 12.5 Functional Description
- 12.6 Interrupts
- 12.7 Low-Power Modes
  - 12.7.1 Wait Mode
  - 12.7.2 Stop Mode
- 12.8 TIMB During Break Interrupts
- 12.9 I/O Signals
  - 12.9.1 TIMB Clock Pin
  - 12.9.2 TIMB Channel I/O Pins
- 12.10 I/O Registers
Section 13. Programmable Interrupt Timer (PIT)
- 13.1 Contents
- 13.2 Introduction
- 13.3 Features
- 13.4 Functional Description
  - 13.4.1 PIT Counter Prescaler
- 13.5 Low-Power Modes
  - 13.5.1 Wait Mode
  - 13.5.2 Stop Mode
- 13.6 PIT During Break Interrupts
- 13.7 I/O Registers
Section 14. Analog-to-Digital Converter (ADC)
- 14.1 Contents
- 14.2 Introduction
- 14.3 Features
- 14.4 Functional Description
- 14.5 Interrupts
- 14.6 Low-Power Modes
  - 14.6.1 Wait Mode
  - 14.6.2 Stop Mode
- 14.7 I/O Signals
- 14.8 I/O Registers
Section 15. Serial Communications Interface Module (SCI)
- 15.1 Contents
- 15.2 Introduction
- 15.3 Features
- 15.4 Pin Name Conventions
- 15.5 Functional Description
- 15.6 Low-Power Modes
  - 15.6.1 Wait Mode
  - 15.6.2 Stop Mode
- 15.7 SCI During Break Module Interrupts
- 15.8 I/O Signals
  - 15.8.1 PTE0/TxD (Transmit Data)
  - 15.8.2 PTE1/RxD (Receive Data)
- 15.9 I/O Registers
Section 16. Serial Peripheral Interface Module (SPI)
- 16.1 Contents
- 16.2 Introduction
- 16.3 Features
- 16.4 Pin Name Conventions and I/O Register Addresses
- 16.5 Functional Description
  - 16.5.1 Master Mode
  - 16.5.2 Slave Mode
- 16.6 Transmission Formats
- 16.7 Queuing Transmission Data
- 16.8 Error Conditions
  - 16.8.1 Overflow Error
  - 16.8.2 Mode Fault Error
- 16.9 Interrupts
- 16.10 Resetting the SPI
- 16.11 Low-Power Modes
  - 16.11.1 Wait Mode
  - 16.11.2 Stop Mode
- 16.12 SPI During Break Interrupts
- 16.13 I/O Signals
- 16.14 I/O Registers
Section 17. Input/Output (I/O) Ports
- 17.1 Contents
- 17.2 Introduction
- 17.3 Port A
  - 17.3.1 Port A Data Register (PTA)
  - 17.3.2 Data Direction Register A (DDRA)
- 17.4 Port B
  - 17.4.1 Port B Data Register (PTB)
  - 17.4.2 Data Direction Register B (DDRB)
- 17.5 Port C
  - 17.5.1 Port C Data Register (PTC)
  - 17.5.2 Data Direction Register C (DDRC)
- 17.6 Port D
- 17.7 Port E
  - 17.7.1 Port E Data Register (PTE)
  - 17.7.2 Data Direction Register E (DDRE)
- 17.8 Port F
- 17.9 Port G
  - 17.9.1 Port G Data Register (PTG)
  - 17.9.2 Data Direction Register G (DDRG)
- 17.10 Port H
  - 17.10.1 Port H Data Register (PTH)
  - 17.10.2 Data Direction Register H (DDRH)
Section 18. External Interrupt (IRQ)
- 18.1 Contents
- 18.2 Introduction
- 18.3 Features
- 18.4 Functional Description
  - 18.4.1 IRQ Pin
- 18.5 IRQ Status and Control Register (ISCR)
- 18.6 IRQ Module During Break Interrupts
Section 19. Keyboard Interrupt Module (KBI)
- 19.1 Contents
- 19.2 Introduction
- 19.3 Features
- 19.4 I/O Pins
- 19.5 Functional Description
- 19.6 Wait Mode
- 19.7 Stop Mode
- 19.8 Keyboard Module During Break Interrupts
Section 20. Computer Operating Properly (COP)
- 20.1 Contents
- 20.2 Introduction
- 20.3 Functional Description
- 20.4 I/O Signals
- 20.5 COP Control Register
- 20.6 Interrupts
- 20.7 Monitor Mode
- 20.8 Low-Power Modes
  - 20.8.1 Wait Mode
  - 20.8.2 Stop Mode
- 20.9 COP Module During Break Mode
Section 21. Low-Voltage Inhibit (LVI)
- 21.1 Contents
- 21.2 Introduction
- 21.3 Features
- 21.4 Functional Description
- 21.5 LVI Status Register (LVISR)
- 21.6 LVI Interrupts
- 21.7 Low-Power Modes
  - 21.7.1 Wait Mode
  - 21.7.2 Stop Mode
Section 22. Break Module (BRK)
- 22.1 Contents
- 22.2 Introduction
- 22.3 Features
- 22.4 Functional Description
- 22.5 Low-Power Modes
  - 22.5.1 Wait Mode
  - 22.5.2 Stop Mode
- 22.6 Break Module Registers
Section 23. Electrical Specifications
- 23.1 Contents
- 23.2 Introduction
- 23.3 Absolute Maximum Ratings
- 23.4 Functional Operating Range
- 23.5 Thermal Characteristics
- 23.6 5.0-V DC Electrical Characteristics
- 23.7 EEPROM and Memory Characteristics
- 23.8 5.0-V Control Timing
- 23.9 Timer Interface Module Characteristics
- 23.10 ADC Characteristics
- 23.11 SPI Characteristics
- 23.12 Clock Generation Module Characteristics
- 23.13 FLASH Memory Characteristics
Section 24. Mechanical Specifications
- 24.1 Contents
- 24.2 Introduction
- 24.3 64-Pin Plastic Quad Flat Pack (QFP)
Section 25. Ordering Information
- 25.1 Contents
- 25.2 Introduction
- 25.3 MC Order Numbers

Input/Output (I/O) Ports

Technical Data MC68HC908AB32 — Rev. 1.1

314 Input/Output (I/O) Ports Freescale Semiconductor

Table 17-1. Port Control Register Bits Summary (Sheet 1 of 2)

Port Bit DDR

Module Control

Module Register Control Bit

0 DDRA0

———

PTA0

1 DDRA1 PTA1

2 DDRA2 PTA2

3 DDRA3 PTA3

4 DDRA4 PTA4

5 DDRA5 PTA5

6 DDRA6 PTA6

7 DDRA7 PTA7

0 DDRB0

ADC

ADSCR

$0038

ADCH[4:0]

PTB0/ATD0

1 DDRB1 PTB1/ATD1

2 DDRB2 PTB2/ATD2

3 DDRB3 PTB3/ATD3

4 DDRB4 PTB4/ATD4

5 DDRB5 PTB5/ATD5

6 DDRB6 PTB6/ATD6

7 DDRB7 PTB7/ATD7

0 DDRC0

———

PTC0

1 DDRC1 PTC1

2 DDRC2

—

DDRC

$0006

MCLKEN PTC2/MCLK

3 DDRC3

——

—

PTC3

4 DDRC4 PTC4

5 DDRC5 PTC5

0 DDRD0

———

PTD0

1 DDRD1 PTD1

2 DDRD2 PTD2

3 DDRD3 PTD3

4 DDRD4 TIMB

TBSC

$0040

PS[2:0] PTD4/TBCLK

5 DDRD5 — — — PTD5

6 DDRD6 TIMA

TASC

$0020

PS[2:0] PTD6/TACLK

7 DDRD7 — — — PTD7