Datasheet

Serial Communications Interface Module (SCI)
MC68HC908AB32 — Rev. 1.1 Technical Data
Freescale Semiconductor Serial Communications Interface Module (SCI)
255
tolerance is much more than the degree of misalignment that is likely to
occur.
As the receiver samples an incoming character, it resynchronizes the RT
clock on any valid falling edge within the character. Resynchronization
within characters corrects misalignments between transmitter bit times
and receiver bit times.
Slow Data Tolerance
Figure 15-7 shows how much a slow received character can be
misaligned without causing a noise error or a framing error. The slow
stop bit begins at RT8 instead of RT1 but arrives in time for the stop bit
data samples at RT8, RT9, and RT10.
Figure 15-7. Slow Data
For an 8-bit character, data sampling of the stop bit takes the receiver
9 bit times × 16 RT cycles + 10 RT cycles = 154 RT cycles.
With the misaligned character shown in Figure 15-7, the receiver counts
154 RT cycles at the point when the count of the transmitting device is
9 bit times × 16 RT cycles + 3 RT cycles = 147 RT cycles.
The maximum percent difference between the receiver count and the
transmitter count of a slow 8-bit character with no errors is
For a 9-bit character, data sampling of the stop bit takes the receiver
10 bit times × 16 RT cycles + 10 RT cycles = 170 RT cycles.
MSB STOP
RT1 RT2 RT3 RT4 RT5 RT6 RT7 RT8 RT9
RT10 RT11 RT12 RT13 RT14 RT15 RT16
DATA
SAMPLES
RECEIVER
RT CLOCK
154 147–
154
--------------------------
100× 4.54%=