Datasheet

Serial Peripheral Interface (SPI)
Technical Data MC68HC908GR8 — Rev 4.0
306 Serial Peripheral Interface (SPI) MOTOROLA
out (MISO), and master out/slave in (MOSI) pins are directly connected
between the master and the slave. The MISO signal is the output from
the slave, and the MOSI signal is the output from the master. The SS line
is the slave select input to the slave. The slave SPI drives its MISO
output only when its slave select input (SS) is at logic 0, so that only the
selected slave drives to the master. The SS pin of the master is not
shown but is assumed to be inactive. The SS pin of the master must be
high or must be reconfigured as general-purpose I/O not affecting the
SPI. See Mode Fault Error. When CPHA = 1, the master begins driving
its MOSI pin on the first SPSCK edge. Therefore, the slave uses the first
SPSCK edge as a start transmission signal. The SS pin can remain low
between transmissions. This format may be preferable in systems
having only one master and only one slave driving the MISO data line.
Figure 20-6. Transmission Format (CPHA = 1)
BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 LSB
MSB
BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 LSB
MSB
12345678
SPSCK CYCLE #
FOR REFERENCE
SPSCK; CPOL = 0
SPSCK; CPOL =1
MOSI
FROM MASTER
MISO
FROM SLAVE
SS
; TO SLAVE
CAPTURE STROBE
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...