Datasheet

56F8037/56F8027 Data Sheet, Rev. 8
142 Freescale Semiconductor
10.1.1 ElectroStatic Discharge (ESD) Model
1. Theta-JA determined on 2s2p test boards is frequently lower than would be observed in an application. Determined on 2s2p
thermal test board.
2. Junction to ambient thermal resistance, Theta-JA (R
JA
), was simulated to be equivalent to the JEDEC specification JESD51-2
in a horizontal configuration in natural convection. Theta-JA was also simulated on a thermal test board with two internal planes
(2s2p, where “s” is the number of signal layers and “p” is the number of planes) per JESD51-6 and JESD51-7. The correct name
for Theta-JA for forced convection or with the non-single layer boards is Theta-JMA.
3. Junction to case thermal resistance, Theta-JC (R
JC
), was simulated to be equivalent to the measured values using the cold plate
technique with the cold plate temperature used as the “case” temperature. The basic cold plate measurement technique is de-
scribed by MIL-STD 883D, Method 1012.1. This is the correct thermal metric to use to calculate thermal performance when the
package is being used with a heat sink.
4. Junction to board thermal resistance, Theta-JB (R
JB
), is a metric of the thermal resistance from the junction to the printed circuit
board determined per JESD51-8. Board temperature is measured on the top surface of the board near the package.
5. Thermal Characterization Parameter, Psi-JT (Y
JT
), is the “resistance” from junction to reference point thermocouple on top center
of case as defined in JESD51-2. Y
JT
is a useful value to use to estimate junction temperature in steady state customer
environments.
6. Junction temperature is a function of die size, on-chip power dissipation, package thermal resistance, mounting site (board)
Table 10-2 56F8037/56F8027 ESD Protection
Characteristic Min Typ Max Unit
ESD for Human Body Model (HBM) 2000 — — V
ESD for Machine Model (MM) 200 — — V
ESD for Charge Device Model (CDM) 750 — — V
Table 10-3 LQFP Package Thermal Characteristics
6
Characteristic
Comments
Symbol
Value
(LQFP)
Unit Notes
Junction to ambient
Natural convection
Single layer board
(1s)
R
JA
41 °C/W 2
Junction to ambient
Natural convection
Four layer board
(2s2p)
R
JMA
34 °C/W 1, 2
Junction to ambient
(@200 ft/min)
Single layer board
(1s)
R
JMA
34 °C/W 2
Junction to ambient
(@200 ft/min)
Four layer board
(2s2p)
R
JMA
29 °C/W 1, 2
Junction to board R
JB
24 °C/W 4
Junction to case R
JC
8°C/W3
Junction to package top Natural Convection 
JT
2°C/W5