Datasheet

Register Descriptions
56F8037/56F8027 Data Sheet, Rev. 8
Freescale Semiconductor 123
6.3.22.4 Select Peripheral Input Source for SYNC Input to DAC 0
(IPS1_DSYNC0)—Bits 2–0
This field selects the alternate input source signal to feed DAC0 SYNC input.
• 000 = PIT0 (Internal) - Use Programmable Interval Timer 0 Output as DAC SYNC input (default)
• 001 = PIT1 (Internal) - Use Programmable Interval Timer 1 Output as DAC SYNC input
• 010 = PIT2 (Internal) - Use Programmable Interval Timer 2 Output as DAC SYNC input
• 011 = PWM SYNC (Internal) - Use PWM reload synchronization signal as DAC SYNC input
• 100 = TA0 (Internal) - Use Timer A0 output as DAC SYNC input
• 101 = TA1 (Internal) - Use Timer A1 output as DAC SYNC input
• 11x = Reserved
6.3.23 Internal Peripheral Source Select Register 2 for Quad Timer A
(SIM_IPS2)
See Section 6.3.21 for general information about Internal Peripheral Source Select registers.
Figure 6-27 Internal Peripheral Source Select Register for TMRA (SIM_IPS2)
6.3.23.1 Reserved—Bits 15–13
This bit field is reserved. Each bit must be set to 0.
6.3.23.2 Select Peripheral Input Source for TA3 (IPS2_TA3)—Bit 12
This field selects the alternate input source signal to feed Quad Timer A, input 3.
• 0 = I/O pin (External) - Use Timer A3 input/output pin
• 1 = PWM SYNC (Internal) - Use PWM reload synchronization signal
6.3.23.3 Reserved—Bits 11–9
This bit field is reserved. Each bit must be set to 0.
6.3.23.4 Select Peripheral Input Source for TA2 (IPS2_TA2)—Bit 8
This field selects the alternate input source signal to feed Quad Timer A, input 2.
• 0 = I/O pin (External) - Use Timer A2 input/output pin
• 1 = CMPBO (Internal) - Use Comparator B output
Base + $1A 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Read
0 0 0
IPS2_
TA3
0 0 0
IPS2_
TA2
0 0 0
IPS2_
TA1
0 0 0 0
Write
RESET
0000000000000000