Datasheet

Table Of Contents
56F8035/56F8025 Signal Pins
56F8035/56F8025 Data Sheet, Rev. 6
Freescale Semiconductor 31
GPIOC7
(ANB3)
(V
REFLB
)
10 Input/
Output
Analog
Input
Input
Input Port C GPIO — This GPIO pin can be individually programmed as
an input or output pin.
ANB3 — Analog input to ADC B, Channel 3.
V
REFLB
— Analog reference voltage low (ADC B).
After reset, the default state is GPIOC7.
GPIOD4
(EXTAL)
38 Input/
Output
Analog
Input
Input Port D GPIO — This GPIO pin can be individually programmed as
an input or output pin.
External Crystal Oscillator Input — This input can be connected to
an 8MHz external crystal. Tie this pin low if XTAL is being driven by
an external clock source.
After reset, the default state is GPIOD4.
GPIOD5
(XTAL)
(CLKIN)
37 Input/
Output
Analog
Input/
Output
Input
Input Port D GPIO — This GPIO pin can be individually programmed as
an input or output pin.
External Crystal Oscillator Output — This output connects the
internal crystal oscillator output to an external crystal.
External Clock Input — This pin serves as an external clock input.
After reset, the default state is GPIOD5.
TDI
(GPIOD0)
41 Input
Input/
Output
Input,
internal
pull-up
enabled
Test Data Input — This input pin provides a serial input data stream
to the JTAG/EOnCE port. It is sampled on the rising edge of TCK
and has an on-chip pull-up resistor.
Port D GPIO — This GPIO pin can be individually programmed as
an input or output pin.
After reset, the default state is TDI.
Return to Table 2-2
Table 2-3 56F8035/56F8025 Signal and Package Information for the 44-Pin LQFP
Signal
Name
LQFP
Pin No.
Type
State During
Reset
Signal Description