Datasheet

LPC2114_2124 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2011. All rights reserved.
Product data sheet Rev. 7 — 10 June 2011 8 of 42
NXP Semiconductors
LPC2114/2124
Single-chip 16/32-bit microcontrollers
P1[16]/
TRACEPKT0
16 O Trace Packet, bit 0. Standard I/O port with internal pull-up.
P1[17]/
TRACEPKT1
12 O Trace Packet, bit 1. Standard I/O port with internal pull-up.
P1[18]/
TRACEPKT2
8 O Trace Packet, bit 2. Standard I/O port with internal pull-up.
P1[19]/
TRACEPKT3
4 O Trace Packet, bit 3. Standard I/O port with internal pull-up.
P1[20]/
TRACESYNC
48 O Trace Synchronization. Standard I/O port with internal pull-up.
Note: LOW on this pin while RESET
is LOW, enables pins P1[25:16] to operate as
Trace port after reset.
P1[21]/
PIPESTAT0
44 O Pipeline Status, bit 0. Standard I/O port with internal pull-up.
P1[22]/
PIPESTAT1
40 O Pipeline Status, bit 1. Standard I/O port with internal pull-up.
P1[23]/
PIPESTAT2
36 O Pipeline Status, bit 2. Standard I/O port with internal pull-up.
P1[24]/
TRACECLK
32 O Trace Clock. Standard I/O port with internal pull-up.
P1[25]/EXTIN0 28 I External Trigger Input. Standard I/O with internal pull-up.
P1[26]/RTCK 24 I/O Returned Test Clock output. Extra signal added to the JTAG port. Assists debugger
synchronization when processor frequency varies. Bidirectional pin with internal
pull-up.
Note: LOW on this pin while RESET
is LOW, enables pins P1[31:26] to operate as
Debug port after reset.
P1[27]/TDO 64 O Test Data out for JTAG interface.
P1[28]/TDI 60 I Test Data in for JTAG interface.
P1[29]/TCK 56 I Test Clock for JTAG interface. This clock must be slower than
1
⁄
6
of the CPU clock
(CCLK) for the JTAG interface to operate.
P1[30]/TMS 52 I Test Mode Select for JTAG interface.
P1[31]/TRST
20 I Test Reset for JTAG interface.
n.c. 10 pin not connected.
RESET
57 I external reset input; a LOW on this pin resets the device, causing I/O ports and
peripherals to take on their default states, and processor execution to begin at
address 0. TTL with hysteresis, 5 V tolerant.
XTAL1 62 I input to the oscillator circuit and internal clock generator circuits.
XTAL2 61 O output from the oscillator amplifier.
V
SS
6, 18, 25,
42, 50
I ground: 0 V reference.
V
SSA
59 I analog ground; 0 V reference. This should nominally be the same voltage as V
SS
,
but should be isolated to minimize noise and error.
V
SSA(PLL)
58 I PLL analog ground; 0 V reference. This should nominally be the same voltage as
V
SS
, but should be isolated to minimize noise and error.
V
DD(1V8)
17, 49 I 1.8 V core power supply; this is the power supply voltage for internal circuitry.
Table 3. Pin description …continued
Symbol Pin Type Description