Datasheet

LPC178X_7X All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 5 — 9 September 2014 18 of 122
NXP Semiconductors
LPC178x/7x
32-bit ARM Cortex-M3 microcontroller
P1[16] 180 D10 B8 125
[3]
I;
PU
I/O P1[16] — General purpose digital input/output pin.
O ENET_MDC — Ethernet MIIM clock.
O I2S_TX_MCLK — I2S transmit master clock.
P1[17] 178 A9 C9 123
[3]
I;
PU
I/O P1[17] — General purpose digital input/output pin.
I/O ENET_MDIO — Ethernet MIIM data input and output.
O I2S_RX_MCLK — I2S receive master clock.
P1[18] 66 P7 L5 46
[3]
I;
PU
I/O P1[18] — General purpose digital input/output pin.
O USB_UP_LED1 — It is LOW when the device is configured
(non-control endpoints enabled), or when the host is enabled
and has detected a device on the bus. It is HIGH when the
device is not configured, or when host is enabled and has not
detected a device on the bus, or during global suspend. It
transitions between LOW and HIGH (flashes) when the host is
enabled and detects activity on the bus.
O PWM1[1] — Pulse Width Modulator 1, channel 1 output.
I T1_CAP0 — Capture input for Timer 1, channel 0.
- R — Function reserved.
I/O SSP1_MISO — Master In Slave Out for SSP1.
P1[19] 68 U6 P5 47
[3]
I;
PU
I/O P1[19] — General purpose digital input/output pin.
O USB_TX_E1
— Transmit Enable signal for USB port 1 (OTG
transceiver).
O USB_PPWR1
— Port Power enable signal for USB port 1.
I T1_CAP1 — Capture input for Timer 1, channel 1.
O MC_0A — Motor control PWM channel 0, output A.
I/O SSP1_SCK — Serial clock for SSP1.
O U2_OE — RS-485/EIA-485 output enable signal for UART2.
P1[20] 70 U7 K6 49
[3]
I;
PU
I/O P1[20] — General purpose digital input/output pin.
O USB_TX_DP1 — D+ transmit data for USB port 1 (OTG
transceiver).
O PWM1[2] — Pulse Width Modulator 1, channel 2 output.
I QEI_PHA — Quadrature Encoder Interface PHA input.
I MC_FB0 — Motor control PWM channel 0 feedback input.
I/O SSP0_SCK — Serial clock for SSP0.
O LCD_VD[6] — LCD data.
O LCD_VD[10] — LCD data.
Table 3. Pin description
…continued
Not all functions are available on all parts. See Table 2 (Ethernet, USB, LCD, QEI, SD/MMC, DAC pins) and Table 7 (EMC
pins).
Symbol
Pin LQFP208 Ball TFBGA208 Ball TFBGA180 Pin LQFP144 Reset state
[1]
Type
[2]
Description