Datasheet

LPC1315_16_17_45_46_47 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2012. All rights reserved.
Product data sheet Rev. 3 — 20 September 2012 63 of 77
NXP Semiconductors
LPC1315/16/17/45/46/47
32-bit ARM Cortex-M3 microcontroller
12.3 XTAL Printed-Circuit Board (PCB) layout guidelines
The crystal should be connected on the PCB as close as possible to the oscillator input
and output pins of the chip. Take care that the load capacitors C
x1
, C
x2
, and C
x3
in case of
third overtone crystal usage have a common ground plane. The external components
must also be connected to the ground plain. Loops must be made as small as possible in
order to keep the noise coupled in via the PCB as small as possible. Also parasitics
should stay as small as possible. Values of C
x1
and C
x2
should be chosen smaller
accordingly to the increase in parasitics of the PCB layout.
5 MHz - 10 MHz 10 pF < 300 18 pF, 18 pF
20 pF < 200 39 pF, 39 pF
30 pF < 100 57 pF, 57 pF
10 MHz - 15 MHz 10 pF < 160 18 pF, 18 pF
20 pF < 60 39 pF, 39 pF
15 MHz - 20 MHz 10 pF < 80 18 pF, 18 pF
Table 19. Recommended values for C
X1
/C
X2
in oscillation mode (crystal and external
components parameters) high frequency mode
Fundamental oscillation
frequency F
OSC
Crystal load
capacitance C
L
Maximum crystal
series resistance R
S
External load
capacitors C
X1
, C
X2
15 MHz - 20 MHz 10 pF < 180 18 pF, 18 pF
20 pF < 100 39 pF, 39 pF
20 MHz - 25 MHz 10 pF < 160 18 pF, 18 pF
20 pF < 80 39 pF, 39 pF
Table 18. Recommended values for C
X1
/C
X2
in oscillation mode (crystal and external
components parameters) low frequency mode
Fundamental oscillation
frequency F
OSC
Crystal load
capacitance C
L
Maximum crystal
series resistance R
S
External load
capacitors C
X1
, C
X2