Datasheet
LPC11E6X All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 1.2 — 21 May 2014 46 of 89
NXP Semiconductors
LPC11E6x
32-bit ARM Cortex-M0+ microcontroller
[1] Typical ratings are not guaranteed. The values listed are for room temperature (25 C), nominal supply voltages.
[2] T
amb
=25C.
[3] I
DD
measurements were performed with all pins configured as GPIO outputs driven LOW and pull-up resistors disabled.
[4] IRC enabled; system oscillator disabled; system PLL disabled.
[5] System oscillator enabled; IRC disabled; system PLL disabled.
[6] BOD disabled.
[7] All peripherals disabled in the SYSAHBCLKCTRL register. Peripheral clocks to USART, CLKOUT, and IOCON disabled in system
configuration block.
[8] IRC enabled; system oscillator disabled; system PLL enabled.
[9] IRC disabled; system oscillator enabled; system PLL enabled.
[10] All oscillators and analog blocks turned off.
[11] WAKEUP pin pulled HIGH externally.
[12] Low-current mode PWR_LOW_CURRENT selected when running the set_power routine in the power profiles.
[13] Including voltage on outputs in tri-state mode.
[14] Tri-state outputs go into tri-state mode in Deep power-down mode.
I
pd
pull-down current V
I
=5V
[16]
10 50 150 A
I
pu
pull-up current V
I
=0V
[16]
10 50 85 A
V
DD
<V
I
<5V 0 0 0 A
I
2
C-bus pins (PIO0_4 and PIO0_5); see Figure 13
V
IH
HIGH-level input
voltage
0.7 V
DD
-- V
V
IL
LOW-level input voltage - - 0.3 V
DD
V
V
hys
hysteresis voltage 0.05 V
DD
-- V
I
OL
LOW-level output
current
V
OL
=0.4V; I
2
C-bus pins
configured as standard mode pins
3.5 - - mA
I
OL
LOW-level output
current
V
OL
=0.4V; I
2
C-bus pins
configured as Fast-mode Plus
pins
20 - - mA
I
LI
input leakage current V
I
=V
DD
[17]
-24 A
V
I
= 5 V - 10 22 A
Oscillator pins
V
i(xtal)
crystal input voltage 0.5 1.8 1.95 V
V
o(xtal)
crystal output voltage 0.5 1.8 1.95 V
V
i(rtcx)
32 kHz oscillator input
voltage
on pin RTCXIN
[19]
0.5 - 3.6 V
V
o(rtcx)
32 kHz oscillator output
voltage
on pin RTCXOUT
[19]
0.5 - 3.6 V
Pin capacitance
C
io
input/output
capacitance
pins with analog and digital
functions
[20]
--7.1 pF
I
2
C-bus pins (PIO0_4 and
PIO0_5)
[20]
- - 2.5 pF
pins with digital functions only
[20]
--2.8 pF
Table 8. Static characteristics
…continued
T
amb
=
40
C to +105
C, unless otherwise specified.
Symbol Parameter Conditions Min Typ
[1]
Max Unit