Datasheet

LPC11E3X All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 2.3 — 11 September 2014 67 of 71
NXP Semiconductors
LPC11E3x
32-bit ARM Cortex-M0 microcontroller
14. Revision history
Table 19. Revision history
Document ID Release date Data sheet status Change notice Supersedes
LPC11E3X v.2.3 20140911 Product data sheet LPC11E3X v.2.2
Modifications: Added part LPC11E35FHI33/501.
LPC11E3X v.2.2 20140114 Product data sheet - LPC11E3X v.2.1
Modifications: ISP mode removed from pin PIO0_3 in Table 3.
LPC11E3X v.2.1 20131230 Product data sheet - LPC11E3X v.2
Modifications: Add reserved function to pins PIO0_8/MISO0/CT16B0_MAT0/R/IOH_6 and
PIO0_9/MOSI0/CT16B0_MAT1/R/IOH_7.
LPC11E3X v.2 20131121 Product data sheet - LPC11E3X v.1.1
Modifications:
• Parts LPC11E3HFBD64/401 added.
• 8 kB SRAM block at 0x1000 000 renamed to SRAM0 in Figure 5.
• I/O Handler pins added in Table 3.
• Typical range of watchdog oscillator frequency changed to 9.4 kHz to 2.3 MHz.
• Section 11.7 “I/O Handler software library applications” added.
• Condition V
DD
= 0 V added to Parameter V
I
in Table 5 for clarity.
LPC11E3X v.1.1 20130924 Product data sheet - LPC11E3X v.1
Modifications:
• Table 3: Added “5 V tolerant pad” to RESET/PIO0_0 table note.
• Table 7: Removed BOD interrupt level 0.
• Added Section 11.5 “ADC effective input impedance”.
• Programmable glitch filter is enabled by default. See Section 7.7.1.
• Table 5 “Static characteristics” added Pin capacitance section.
• Table 4 “Limiting values”:
– Updated V
DD
min and max.
– Updated V
I
conditions.
• Table 10 “EEPROM characteristics”:
– Removed f
clk
and t
er
; the user does not have control over these parameters.
– Changed the t
prog
from 1.1 ms to 2.9 ms; the EEPROM IAP always does an erase and
program, thus the total program time is t
er
+ t
prog
.
LPC11E3X v.1 20121107 Objective data sheet - -