Datasheet
LPC11E3X All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 2.3 — 11 September 2014 35 of 71
NXP Semiconductors
LPC11E3x
32-bit ARM Cortex-M0 microcontroller
[1] Typical ratings are not guaranteed. The values listed are at room temperature (25 C), nominal supply voltages.
[2] IRC enabled; system oscillator disabled; system PLL disabled.
[3] I
DD
measurements were performed with all pins configured as GPIO outputs driven LOW and pull-up resistors disabled.
[4] BOD disabled.
[5] All peripherals disabled in the AHBCLKCTRL register. Peripheral clocks to USART, SSP0/1 disabled in the SYSCON block.
[6] Low-current mode PWR_LOW_CURRENT selected when running the set_power routine in the power profiles.
[7] IRC disabled; system oscillator enabled; system PLL enabled.
[8] WAKEUP pin pulled HIGH externally. An external pull-up resistor is required on the RESET
pin for the Deep power-down mode.
[9] Including voltage on outputs in 3-state mode.
[10] 3-state outputs go into 3-state mode in Deep power-down mode.
[11] Allowed as long as the current limit does not exceed the maximum current allowed by the device.
[12] To V
SS
.
I
pu
pull-up current V
I
=0V
2.0 V V
DD
3.6 V
15 50 85 A
1.8 V V
DD
< 2.0 V 10 50 85 A
V
DD
<V
I
<5V 0 0 0 A
I
2
C-bus pins (PIO0_4 and PIO0_5)
V
IH
HIGH-level input
voltage
0.7V
DD
--V
V
IL
LOW-level input voltage - - 0.3V
DD
V
V
hys
hysteresis voltage - 0.05V
DD
-V
I
OL
LOW-level output
current
V
OL
=0.4V; I
2
C-bus pins configured
as standard mode pins
2.0 V V
DD
3.6 V
3.5 - - mA
1.8 V V
DD
< 2.0 V 3 - -
I
OL
LOW-level output
current
V
OL
=0.4V; I
2
C-bus pins configured
as Fast-mode Plus pins
2.0 V V
DD
3.6 V
20 - - mA
1.8 V V
DD
< 2.0 V 16 - -
I
LI
input leakage current V
I
=V
DD
[12]
-24A
V
I
= 5 V - 10 22 A
Oscillator pins
V
i(xtal)
crystal input voltage 0.5 1.8 1.95 V
V
o(xtal)
crystal output voltage 0.5 1.8 1.95 V
Pin capacitance
C
io
input/output
capacitance
pins configured for analog function - - 7.1 pF
I
2
C-bus pins (PIO0_4 and PIO0_5) - - 2.5 pF
pins configured as GPIO - - 2.8 pF
Table 5. Static characteristics
…continued
T
amb
=
40
C to +85
C, unless otherwise specified.
Symbol Parameter Conditions Min Typ
[1]
Max Unit