Datasheet
LPC11E1X All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 1.1 — 24 September 2013 18 of 62
NXP Semiconductors
LPC11E1x
32-bit ARM Cortex-M0 microcontroller
• Synchronous serial communication
• Master or slave operation
• 8-frame FIFOs for both transmit and receive
• 4-bit to 16-bit frame
7.11 I
2
C-bus serial I/O controller
The LPC11E1x contain one I
2
C-bus controller.
The I
2
C-bus is bidirectional for inter-IC control using only two wires: a Serial Clock line
(SCL) and a Serial Data line (SDA). Each device is recognized by a unique address and
can operate as either a receiver-only device (e.g., an LCD driver) or a transmitter with the
capability to both receive and send information (such as memory). Transmitters and/or
receivers can operate in either master or slave mode, depending on whether the chip has
to initiate a data transfer or is only addressed. The I
2
C-bus is a multi-master bus, and
more than one bus master connected to the interface can be controlled the bus.
7.11.1 Features
• The I
2
C-interface is an I
2
C-bus compliant interface with open-drain pins. The I
2
C-bus
interface supports Fast-mode Plus with bit rates up to 1 Mbit/s.
• Easy to configure as master, slave, or master/slave.
• Programmable clocks allow versatile rate control.
• Bidirectional data transfer between masters and slaves.
• Multi-master bus (no central master).
• Arbitration between simultaneously transmitting masters without corruption of serial
data on the bus.
• Serial clock synchronization allows devices with different bit rates to communicate via
one serial bus.
• Serial clock synchronization can be used as a handshake mechanism to suspend and
resume serial transfer.
• The I
2
C-bus can be used for test and diagnostic purposes.
• The I
2
C-bus controller supports multiple address recognition and a bus monitor mode.
7.12 10-bit ADC
The LPC11E1x contains one ADC. It is a single 10-bit successive approximation ADC with
eight channels.
7.12.1 Features
• 10-bit successive approximation ADC.
• Input multiplexing among 8 pins.
• Power-down mode.
• Measurement range 0 V to V
DD
.
• 10-bit conversion time 2.44 s (up to 400 kSamples/s).
• Burst conversion mode for single or multiple inputs.