Datasheet
Table Of Contents
- 1. General description
- 2. Features and benefits
- 3. Applications
- 4. Ordering information
- 5. Block diagram
- 6. Pinning information
- 7. Functional description
- 7.1 ARM Cortex-M0 processor
- 7.2 On-chip flash program memory
- 7.3 On-chip SRAM
- 7.4 Memory map
- 7.5 Nested Vectored Interrupt Controller (NVIC)
- 7.6 IOCONFIG block
- 7.7 Fast general purpose parallel I/O
- 7.8 UART
- 7.9 SPI serial I/O controller
- 7.10 I2C-bus serial I/O controller
- 7.11 C_CAN controller
- 7.12 10-bit ADC
- 7.13 General purpose external event counter/timers
- 7.14 System tick timer
- 7.15 Watchdog timer
- 7.16 Clocking and power control
- 7.17 System control
- 7.18 Emulation and debugging
- 8. Limiting values
- 9. Static characteristics
- 10. Dynamic characteristics
- 11. Application information
- 12. Package outline
- 13. Soldering
- 14. Abbreviations
- 15. Revision history
- 16. Legal information
- 17. Contact information
- 18. Contents
LPC11CX2_CX4 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 3.1 — 15 May 2013 2 of 62
NXP Semiconductors
LPC11Cx2/Cx4
32-bit ARM Cortex-M0 microcontroller
Programmable WatchDog Timer (WDT).
Analog peripherals:
10-bit ADC with input multiplexing among 8 pins.
Serial interfaces:
UART with fractional baud rate generation, internal FIFO, and RS-485 support.
Two SPI controllers with SSP features and with FIFO and multi-protocol
capabilities.
I
2
C-bus interface supporting full I
2
C-bus specification and Fast-mode Plus with a
data rate of 1 Mbit/s with multiple address recognition and monitor mode.
C_CAN controller. On-chip C_CAN and CANopen drivers included.
On-chip, high-speed CAN transceiver (parts LPC11C22/C24 only).
Clock generation:
12 MHz internal RC oscillator trimmed to 1 % accuracy that can optionally be used
as a system clock.
Crystal oscillator with an operating range of 1 MHz to 25 MHz.
Programmable watchdog oscillator with a frequency range of 7.8 kHz to 1.8 MHz.
PLL allows CPU operation up to the maximum CPU rate without the need for a
high-frequency crystal. May be run from the system oscillator or the internal RC
oscillator.
Clock output function with divider that can reflect the system oscillator, IRC, CPU
clock, or the Watchdog clock.
Power control:
Integrated PMU (Power Management Unit) to minimize power consumption during
Sleep, Deep-sleep, and Deep power-down modes.
Three reduced power modes: Sleep, Deep-sleep, and Deep power-down.
Processor wake-up from Deep-sleep mode via a dedicated start logic using 13 of
the GPIO pins.
Power-On Reset (POR).
Brownout detect with four separate thresholds for interrupt and forced reset.
Unique device serial number for identification.
Single 3.3 V power supply (1.8 V to 3.6 V).
Available as 48-pin LQFP package.
3. Applications
eMetering Industrial and sensor based networks
Elevator systems White goods