Datasheet

LPC111X All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 9.2 — 26 March 2014 78 of 127
NXP Semiconductors
LPC1110/11/12/13/14/15
32-bit ARM Cortex-M0 microcontroller
10.7 Power consumption LPC1100XL series
(LPC111x/103/203/303/323/333)
[1] WDT OSC enabled, V
DD
= 3.3 V, Temp = 25 C.
Low-current mode PWR_LOW_CURRENT selected when running the set_power routine in the power profiles.
I
DD
measurements were performed with all pins configured as GPIO outputs driven LOW and pull-up resistors disabled,
IRC disabled, System Oscillator disabled, System PLL disabled, BOD disabled.
All peripherals disabled in the SYSAHBCLKCTRL register. Peripheral clocks to UART and SPI0/1 disabled in system configuration
block.
[2] Typical ratings are not guaranteed. The values listed are at room temperature (25 C), nominal supply voltages.
Table 20. Power consumption at very low frequencies using the watchdog oscillator
Symbol Parameter Conditions
[1]
Min Typ
[2]
Max Unit
I
DD
supply current Active mode; code
while(1){}
executed from flash
system clock = 8.8 kHz - 275 - A
system clock = 257 kHz - 305 - A
system clock = 515 kHz - 335 - A
system clock = 784 kHz - 368 - A
system clock = 1028 kHz - 396 - A
system clock = 2230 kHz - 538 - A
Sleep mode;
system clock = 8.8 kHz - 274 - A
system clock = 257 kHz - 285 - A
system clock = 515 kHz - 295 - A
system clock = 784 kHz - 309 - A
system clock = 1028 kHz - 317 - A
system clock = 2230 kHz - 368 - A