Datasheet

LPC1102_1104 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 7 — 26 September 2013 40 of 43
NXP Semiconductors
LPC1102/1104
32-bit ARM Cortex-M0 microcontroller
14. Revision history
Table 16. Revision history
Document ID Release date Data sheet status Change notice Supersedes
LPC1102_1104 v.7 20130926 Product data sheet - LPC1102_1104 v.6
Modifications:
• Parameter V
I
updated in Table 4 and Table 5. Condition V
DD
= 0 added.
• Section 11.5 “ADC effective input impedance” added.
• Removed t
clk(H)
and t
clk(L)
from Figure 18 “SPI master timing in SPI mode” and Figure
19 “SPI slave timing in SPI mode”; spec not characterized.
LPC1102_1104 v.6 20121231 Product data sheet - LPC1102_1104 v.5
Modifications:
• Added Section 9.3 “CoreMark data”.
• Conditions for power consumption in Deep-sleep mode updated in Table 5, Table
note 8 and Section 9.2.
• Table 4 “Limiting values” expanded for clarity.
• BOD reset level 0 added in Table 7.
LPC1102_1104 v.5 20120727 Product data sheet - LPC1102 v.4
Modifications:
• Added LPC1104UK.
• Removed footnote “The peak current is limited to 25 times the corresponding
maximum current.” from Table 4.
• For parameters I
OL
, V
OL
, I
OH
, V
OH
, changed conditions to 1.8 V  V
DD
< 2.5 V and 2.5
V  V
DD
 3.6 V in Table 5).
• WDOSc frequency range corrected.
• BOD level 0 removed in Table 7.
LPC1102 v.4 20110624 Product data sheet - LPC1102 v.3
Modifications:
• ADC sampling frequency corrected in Table 6 (Table note 7).
• Parameter T
cy(clk)
corrected on Table 14.
• Windowed WDT features added (Section 7.13).
• Programmable open-drain mode added to GPIO pins (Section 7.7).
• Pull-up level specified in Table 3, Table note 1 and Section 7.7.
• Condition for parameter T
stg
in Table 4 updated.
• Table note 4 of Table 4 updated.
LPC1102 v.3 20110418 Product data sheet - LPC1102 v.2
Modifications:
• Changed data sheet status to Product.
• Power consumption data added (see Figure 6 to Figure 9).
• Section 10.1 “Power-up ramp conditions” added.
• Reset pad description updated (5 V tolerant) in Table 3.
• IRC frequency data added (see Figure 16 “Internal RC oscillator frequency versus
temperature”.
• Clock output removed from feature list.
LPC1102 v.2 20101126 Preliminary data sheet - LPC1102 v.1
Modifications:
• Changed data sheet status to Preliminary.
LPC1102 v.1 20101116 Objective data sheet - -