Datasheet

56F826 Technical Data, Rev. 14
22 Freescale Semiconductor
Input capacitance C
IN
—8—pF
Output capacitance C
OUT
—12—pF
V
DD
supply current
I
DDT
5
Run
6
—4775mA
Wait
7
—2136mA
Stop —28mA
Low Voltage Interrupt, V
DDIO
power supply
8
V
EIO
2.4 2.7 3.0 V
Low Voltage Interrupt, V
DD
power supply
9
V
EIC
2.0 2.2 2.4 V
Power on Reset
10
V
POR
—1.72.0V
1.
1. Schmitt Trigger inputs are: EXTBOOT, IRQA, IRQB, RESET, TCS, TCK, TRST, TMS, TDI and RXD1
2. Analog inputs are: ANA[0:7], XTAL and EXTAL. Specification assumes ADC is not sampling.
3. PWM pin output source current measured with 50% duty cycle.
4. PWM pin output sink current measured with 50% duty cycle.
5. I
DDT
= I
DD
+ I
DDA
(Total supply current for V
DD
+ V
DDA
)
6. Run (operating) I
DD
measured using 4MHz clock source. All inputs 0.2V from rail; outputs unloaded. All ports configured as
inputs; measured with all modules enabled.
7. Wait I
DD
measured using external square wave clock source (f
osc
= 4MHz) into XTAL; all inputs 0.2V from rail; no DC loads;
less than 50pF on all outputs. C
L
= 20pF on EXTAL; all ports configured as inputs; EXTAL capacitance linearly affects wait I
DD
;
measured with PLL enabled.
8. This low-voltage interrupt monitors the V
DDIO
power supply. If V
DDIO
drops below V
EIO
, an interrupt is generated. Functionality
of the device is guaranteed under transient conditions when V
DDIO
>V
EIO
(between the minimum specified V
DDIO
and the point when
the V
EIO
interrupt is generated).
9. This low-voltage interrupt monitors theV
DD
power supply. If V
DDIO
drops below V
EIC
, an interrupt is generated. Functionality of
the device is guaranteed under transient conditions when V
DD
>V
EIC
(between the minimum specified V
DD
and the point when the
V
EIC
interrupt is generated).
10. Power–on reset occurs whenever the V
DD
power supply drops below V
POR
. While power is ramping up, this signal remains
active for as long as V
DD
is below V
POR
no matter how long the ramp-up rate is.
Table 3-4 DC Electrical Characteristics (Continued)
Operating Conditions: V
SSIO
=V
SS
= V
SSA
= 0V, V
DDA
=V
DDIO
=3.0–3.6V, V
DD
= 2.25–2.75V, T
A
= –40° to +85°C, C
L
≤ 50pF, f
op
= 80MHz
Characteristic Symbol Min Typ Max Unit