Datasheet
Table Of Contents
- Part 1 Overview
- Part 2 Signal/Connection Descriptions
- 2.1 Introduction
- 2.2 Power and Ground Signals
- 2.3 Clock and Phase Locked Loop Signals
- 2.4 Address, Data, and Bus Control Signals
- 2.5 Interrupt and Program Control Signals
- 2.6 GPIO Signals
- 2.7 Pulse Width Modulator (PWM) Signals
- 2.8 Serial Peripheral Interface (SPI) Signals
- 2.9 Quadrature Decoder Signals
- 2.10 Serial Communications Interface (SCI) Signals
- 2.11 CAN Signals
- 2.12 Analog-to-Digital Converter (ADC) Signals
- 2.13 Quad Timer Module Signals
- 2.14 JTAG/OnCE
- Part 3 Specifications
- 3.1 General Characteristics
- 3.2 DC Electrical Characteristics
- 3.3 AC Electrical Characteristics
- 3.4 Flash Memory Characteristics
- 3.5 External Clock Operation
- 3.6 External Bus Asynchronous Timing
- 3.7 Reset, Stop, Wait, Mode Select, and Interrupt Timing
- 3.8 Serial Peripheral Interface (SPI) Timing
- 3.9 Quad Timer Timing
- 3.10 Quadrature Decoder Timing
- 3.11 Serial Communication Interface (SCI) Timing
- 3.12 Analog-to-Digital Converter (ADC) Characteristics
- 3.13 Controller Area Network (CAN) Timing
- 3.14 JTAG Timing
- Part 4 Packaging
- Part 5 Design Considerations
- Part 6 Ordering Information
External Clock Operation
56F805 Technical Data, Rev. 16
Freescale Semiconductor 31
3.5.4 Phase Locked Loop Timing
Table 3-9 PLL Timing
Operating Conditions: V
SS
= V
SSA
= 0 V, V
DD
= V
DDA
= 3.0–3.6V, T
A
= –40° to +85°C
Characteristic Symbol Min Typ Max Unit
External reference crystal frequency for the PLL
1
1. An externally supplied reference clock should be as free as possible from any phase jitter for the PLL to work
correctly. The PLL is optimized for 8MHz input crystal.
f
osc
4810MHz
PLL output frequency
2
2. ZCLK may not exceed 80MHz. For additional information on ZCLK and f
out
/2, please refer to the OCCS chapter in the
User Manual. ZCLK = f
op
f
out
/2 40 — 110 MHz
PLL stabilization time
3
0
o
to +85
o
C
3. This is the minimum time required after the PLL set-up is changed to ensure reliable operation.
t
plls
—110ms
PLL stabilization time
3
-40
o
to 0
o
C
t
plls
— 100 200 ms