Datasheet
Table Of Contents
- Part 1 Overview
- Part 2 Signal/Connection Descriptions
- 2.1 Introduction
- 2.2 Power and Ground Signals
- 2.3 Clock and Phase Locked Loop Signals
- 2.4 Address, Data, and Bus Control Signals
- 2.5 Interrupt and Program Control Signals
- 2.6 GPIO Signals
- 2.7 Pulse Width Modulator (PWM) Signals
- 2.8 Serial Peripheral Interface (SPI) Signals
- 2.9 Quadrature Decoder Signals
- 2.10 Serial Communications Interface (SCI) Signals
- 2.11 CAN Signals
- 2.12 Analog-to-Digital Converter (ADC) Signals
- 2.13 Quad Timer Module Signals
- 2.14 JTAG/OnCE
- Part 3 Specifications
- 3.1 General Characteristics
- 3.2 DC Electrical Characteristics
- 3.3 AC Electrical Characteristics
- 3.4 Flash Memory Characteristics
- 3.5 External Clock Operation
- 3.6 External Bus Asynchronous Timing
- 3.7 Reset, Stop, Wait, Mode Select, and Interrupt Timing
- 3.8 Serial Peripheral Interface (SPI) Timing
- 3.9 Quad Timer Timing
- 3.10 Quadrature Decoder Timing
- 3.11 Serial Communication Interface (SCI) Timing
- 3.12 Analog-to-Digital Converter (ADC) Characteristics
- 3.13 Controller Area Network (CAN) Timing
- 3.14 JTAG Timing
- Part 4 Packaging
- Part 5 Design Considerations
- Part 6 Ordering Information
56F805 Technical Data, Rev. 16
30 Freescale Semiconductor
3.5.3 External Clock Source
The recommended method of connecting an external clock is given in Figure 3-9. The external clock
source is connected to XTAL and the EXTAL pin is grounded.
Figure 3-9 Connecting an External Clock Signal
Figure 3-10 External Clock Timing
Table 3-8 External Clock Operation Timing Requirements
3
Operating Conditions: V
SS
= V
SSA
= 0 V, V
DD
= V
DDA
= 3.0–3.6V, T
A
= –40° to +85°C
Characteristic Symbol Min Typ Max Unit
Frequency of operation (external clock driver)
1
1. See Figure 3-9 for details on using the recommended connection of an external clock driver.
f
osc
0—80MHz
Clock Pulse Width
2
,
5
2. The high or low pulse width must be no smaller than 6.25ns or the chip will not function. However, the high pulse width
does not have to be any particular percent of the low pulse width.
3. Parameters listed are guaranteed by design.
t
PW
6.25 — — ns
56F805
XTAL
EXTAL
External
V
SS
Clock
External
Clock
V
IH
V
IL
Note: The midpoint is V
IL
+ (V
IH
– V
IL
)/2.
90%
50%
10%
90%
50%
10%
t
PW
t
PW