Datasheet
Table Of Contents
- Part 1 Overview
- Part 2 Signal/Connection Descriptions
- 2.1 Introduction
- 2.2 Power and Ground Signals
- 2.3 Clock and Phase Locked Loop Signals
- 2.4 Address, Data, and Bus Control Signals
- 2.5 Interrupt and Program Control Signals
- 2.6 GPIO Signals
- 2.7 Pulse Width Modulator (PWM) Signals
- 2.8 Serial Peripheral Interface (SPI) Signals
- 2.9 Quadrature Decoder Signals
- 2.10 Serial Communications Interface (SCI) Signals
- 2.11 CAN Signals
- 2.12 Analog-to-Digital Converter (ADC) Signals
- 2.13 Quad Timer Module Signals
- 2.14 JTAG/OnCE
- Part 3 Specifications
- 3.1 General Characteristics
- 3.2 DC Electrical Characteristics
- 3.3 AC Electrical Characteristics
- 3.4 Flash Memory Characteristics
- 3.5 External Clock Operation
- 3.6 External Bus Asynchronous Timing
- 3.7 Reset, Stop, Wait, Mode Select, and Interrupt Timing
- 3.8 Serial Peripheral Interface (SPI) Timing
- 3.9 Quad Timer Timing
- 3.10 Quadrature Decoder Timing
- 3.11 Serial Communication Interface (SCI) Timing
- 3.12 Analog-to-Digital Converter (ADC) Characteristics
- 3.13 Controller Area Network (CAN) Timing
- 3.14 JTAG Timing
- Part 4 Packaging
- Part 5 Design Considerations
- Part 6 Ordering Information
Flash Memory Characteristics
56F805 Technical Data, Rev. 16
Freescale Semiconductor 25
Figure 3-3 Signal States
3.4 Flash Memory Characteristics
Table 3-5 Flash Memory Truth Table
Mode
XE
1
1. X address enable, all rows are disabled when XE = 0
YE
2
2. Y address enable, YMUX is disabled when YE = 0
SE
3
3. Sense amplifier enable
OE
4
4. Output enable, tri-state Flash data out bus when OE = 0
PROG
5
5. Defines program cycle
ERASE
6
6. Defines erase cycle
MAS1
7
7. Defines mass erase cycle, erase whole block
NVSTR
8
8. Defines non-volatile store cycle
Standby L L L L L L L L
Read HHHH L L L L
Word Program H H L L H L L H
Page Erase H L L L L H L H
Mass Erase H L L L L H H H
Table 3-6 IFREN Truth Table
Mode IFREN = 1 IFREN = 0
Read Read information block Read main memory block
Word program Program information block Program main memory block
Page erase Erase information block Erase main memory block
Mass erase Erase both block Erase main memory block
Data Invalid State
Data1
Data2 Valid
Data
Tri-stated
Data3 Valid
Data2 Data3
Data1 Valid
Data Active Data Active