Datasheet

NXP Semiconductors
AN11211
Blueboard Quick Startup Guide
a. Uncomment the line #define I2C_USED.
b. Comment the line #define SPI_USED.
7.7 Removing the initial breakpoint on debug startup
When the debugger starts, it automatically sets a breakpoint at the first statement in the
main() function. One can remove this breakpoint as follows:
1. Right click on the project and choose Launch Configurations  Edit current…
Fig 38. Open Current Launch Configuration
1. Choose the Debug configuration
2. Choose the tab Debugger
3. Uncheck the box near “Stop on startup at:”
4. Click onto Apply and then Close.
AN11211 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Application note
COMPANY PUBLIC
Rev. 1.9 — 1 December 2014
226219
30 of 36